Table of Contents
Advertisement
Operation Manual / 4 Product description / A130-M.. - A145-M..
2 Removing and Installing / 2.3 Installing the turbocharger
Observe the instructions for the fastening variant at hand.
u
¡
Fastening the turbocharger with a standard nut →17
¡
Fastening the turbocharger with a clamping nut →18
2.3.4
Fastening the turbocharger with a standard nut
Fit the nuts and tighten them according to variant 1 or 2 in the table below.
u
Product
Through hole in
bearing casing
[mm]
A130
Ø 17
A135
Ø 21
A140
Ø 25
Table 4: Tightening torque for standard nuts
**) When the turbocharger is mounted on the engine support, the bolt threads and screw
heads must be lightly oiled (assumed friction coefficient µ = 0.12 for tightening torque)
Remove the lifting gear.
u
© Copyright 2019 ABB. All rights reserved.
Fixing screws
Variant 1: Tightening
[mm]
torques [Nm] **)
M16
M20
M24
HZTL4031_EN
(A130 - A140)
(A140 and A145)
Variant 2: Hy-
draulic pre-ten-
sioning forces [kN]
280
560
960
Revision H
110
175
250
March 2019
Advertisement
Chapters
Table of Contents
