Canon imageRUNNER 7095 Service Manual page 513

Hide thumbs Also See for imageRUNNER 7095:

Table of Contents

Use it to specify the clutch whose operation you want to check. (settings: 1 to 21)

1) Select the item.

2) Type in the appropriate number using the keypad.

3) Press the OK key.

Use it to start a check on the operation of a clutch.

1) Select the item, and press the OK key so that the clutch repeatedly goes on and off as

on for 05 sec -> off for 10 sec -> on for 0.5 sec -> off for 10 sec -> on for 0.5 speed -> off

Use it to select a motor whose operation you want to check. (settings: 1 to 13)

1) Select the item.

2) Type in the appropriate number using the keypad.

3) Press the OK key.

MTR-ON Use it to start a check on the operation of a motor.

1) Select the item, and press the OK key.

- on for 20 sec -> off

- if buffer motor or duplexing horizontal registration motor, on for 10 sec -> off

- if shift tray motor, stops at front/rear HP

- if vibration motor (M10/M20), repeats on and off at intervals of about 5 sec

Use it to select the operation of a solenoid.

1) Select the item.

2) Enter the appropriate number using the keypad.

3) Press the OK key.

Use it to start a check on the operation of a solenoid.

1) Select the item, and press the OK key.

on for 0.5 sec -> off for 5 sec -> on for 0.5 sec -> off for 5 sec, on for 0.5 sec -> of

Initial Setup/

COPIER > FUNCTION > PART-CHK

Authenticate

Check Counter BILL

Chapters

Table of Contents

Imagerunner 7105 Imagerunner 7086