Epson C80 CFS Installation Instructions

Download this manual

Installation Instructions: Epson C80 CFS

Prerequisite -

Before starting this installation, you MUST test your printer to make sure it is printing

100% correctly. If this is a new printer, follow the Epson procedures for installing and

testing the cartridges. It must print properly with these cartridge before the CFS can be

installed. The best way to do this is first print a Nozzle pattern, using the printer utility

software provided by Epson. If the nozzle pattern is perfect, then print 5 copies of the

MIS PURGE4.TIF image using the Plain Paper and 360 dpi settings on the printer. The

Purge4 image can be found on the diskette included with your system or download it from

our website. All 5 pages must print without banding or skipping (white spaces). If your

printer can not do this, do not install the CFS. Run some cleaning cycles until you can pass

this test.

Tools & Materials Needed -

MIS CFS System, Ink and a working Epson C82 printer

•

Ruler or measuring tape

•

Small amount of black electrical tape

•

Pair of Scissors

•

Alcohol and some paper towels

•

Some paper to print on

•

S a v e

M o n e y

MIS Associates Inc

http://www.inksupply.com

a n d

I m p r o v e

2901 Auburn Rd

Fax: 248-289-6013

Y o u r

Auburn Hills, MI 48326

Email: sales@inksupply.com

P r i n t i n g

800-445-8296

Page 1 The best way to do this is first print a Nozzle pattern, using the printer utility software provided by Epson. If the nozzle pattern is perfect, then print 5 copies of the MIS PURGE4.TIF image using the Plain Paper and 360 dpi settings on the printer. The Purge4 image can be found on the diskette included with your system or download it from our website.
Page 2 3. Remove the Epson cartridges and PARTIALLY install the CFS cartridges. Do not push the cartridges all the way down. We do not want the seals on the bottom to be punctured until the tubes have been installed in the bottles.
Page 3 Top of printer does not have to be removed. 5. Clean and dry the top of the printer housing with alcohol and place the Right Hand Bracket as shown in the photo. Lubricate tubes with alcohol and slide them into the Right Hand Bracket.
Page 4 This has worked on many Epson printers in the past. It gives the air bubbles in the ink a chance to rise to the surface and get out of the printhead.