Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Oki Hard Disk Drive
Summary of Contents for Oki Hard Disk Drive
-
Page 1: Installation Instructions
Hard Disk Drive (HDD) Installation Instructions 59393401... -
Page 2: Trademark Information
© 2007 by Oki Data Americas, Inc. All rights reserved. Document P/N 59383401 Disclaimer Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. The manufacturer assumes no responsibility for the results of errors beyond its control. -
Page 3: Installation
Installation 1. Turn off the printer and detach the power cord from the back of the printer. 2. Detach the interface cable. - Page 4 3. Open the top cover.
- Page 5 Warning! If the printer has been powered on recently, the fuser will be hot. This area is clearly labeled. 4. Press the release and open the front cover.
- Page 6 5. Loosen the thumbscrew holding the printer side panel in place.
- Page 7 6. Lift up on the ends of the side panel, then remove it from the printer.
- Page 8 7. Slide the access door in the metal plate and open it. 8. Remove the HDD from its shipping package. Caution! Observe antistatic precautions when installing the hard disk drive.
- Page 9 9. Plug the connecting cable (1) firmly into the connector (2) on the printer, then tighten the two thumbscrews (3).
- Page 10 10. Close the access cover and slide it to secure it in the metal plate. 11. Replace the side panel on the printer.
- Page 11 12. Use the thumbscrew to secure the panel. 13. Close the front cover.
- Page 12 14. Close the top cover. 15. Attach the interface cable. 16. Plug the power cord into the back and turn on the printer.
-
Page 13: Verify The Installation
The MenuMap prints. 3. Look at the top of the printout: “HDD: installed” should appear. If you see “HDD: uninstalled”, repeat the installation steps—checking to be sure that the Hard Disk Drive is firmly seated in the printer connector—until it does. - Page 14 Activate the HDD in the Driver Windows Postscript Emulation Driver 1. First Windows Vista a. Click Start → Settings → [Hardware and Sound] Printer. The Printer dialog box opens. Windows XP, Server 2003 a. Click Start → Settings → Printers and Faxes.
-
Page 15: Pcl Driver
5. Select Installed. 6. Click OK and close the dialog box. PCL Driver 1. First Windows Vista a. Click Start → Settings → [Hardware and Sound] Printer. The Printer dialog box opens. Windows XP, Server 2003 a. Click Start → Settings → Printers and Faxes. - Page 16 3. Click Printer → Setup. 4. Click Configure. 5. Select Hard Disk in the Change drop-down menu. 6. Change the setting of the next drop-down menu to Installed. 7. Click OK twice and close Chooser. Mac OS 10.2, 10.3, 10.4 1.