Preparation For Adjustment; Reading Of Parameter - Sony SSC-M183 Service Manual
Black and white video camera & color video camera
Hide thumbs
Also See for SSC-M183:
- Brochure & specs (4 pages) ,
- Operating instructions (2 pages) ,
- Catalog (48 pages)
Table of Contents
Advertisement
2-3-2. Preparation for Adjustment
1. Connect one end of the RS-232C cable to the COM
(RS-232C) port of the personal computer (referred to
as PC hereafter) and other end to the connector (CN1)
on the adjusting tool board.
2. Perform the setting of camera with the switches on the
rear panel.
3. Connect the harness connector of the adjusting tool
board to the connector (CN205) on the PC-2001 board.
4. Turn on the power of camera and PC.
5. After starting the PC, start the adjustment software
"BoxCam.exe".
6. The setting screen is displayed. In "SelectCOM",
select the port to which the RS-232C cable is
connected.
7. Press OK. The setting of BoxCam adjustment software
is completed.
Name of switch
Sync switch
AGC ON/OFF switch
BLC ON/OFF switch
CCD IRIS ON/OFF switch
SSC-M183/M183CE/M188CE/M383/M383CE/M388CE
SSC-DC193/DC193P/DC198P/DC393/DC393P/DC398P
SSC-DC193
SSC-DC198P
SSC-DC193P
SSC-DC398P
SSC-DC393
SSC-DC393P
INT
—
OFF
OFF
OFF
OFF
OFF
OFF
2-3-3. Reading of Parameter
1. Check that the "START" button of the PC adjustment
software is in active state, then press the "START"
button.
n
To make the "START" button active state, press the
TAB key several times. Be extremely careful when the
"START" button is not in active state, because it is
likely that the previous adjustment has not been
completed.
Active state
2. Reading of parameter of camera is completed.
Check that the following screen is displayed, then turn
off the power of camera.
3. Turn on the power of camera again and check that the
screen is displayed. Then, click the OK button of the
above message.
Not in active state
2-5
Hide quick links:
Advertisement
Table of Contents
