ABB ACS150 User Manual page 45
Hide thumbs
Also See for ACS150:
- User manual (173 pages) ,
- Installation instructions (4 pages) ,
- Quick installation and start-up manual (2 pages)
Table of Contents
Advertisement
Operation
You operate the control panel with the help of menus and keys. You select an option
(e.g. operation mode or parameter) by scrolling the
the option is visible in the display and then pressing the
With the
changes.
The ACS150 includes an integrated potentiometer located at the front of the drive. It
is used for setting the frequency reference.
The Integrated Control Panel has six panel modes: Output, Reference, Short
Parameter, Long Parameter, Changed Parameters and Fault. The operation in the
first five modes is described in this chapter. When a fault or alarm occurs, the panel
goes automatically to the Fault mode showing the fault or alarm code. You can reset
the fault or alarm in the Output or Fault mode (see chapter
When the power is switched on, the panel is in the Output mode, where you can
start, stop, change the direction, switch between local and remote control, monitor
up to three actual values (one at a time) and set the frequency reference. To do other
tasks, go first to the Main menu and select the appropriate mode. The figure below
shows how to move between modes.
491
LOC
.
OUTPUT
FWD
Output mode (p. 49)
The panel goes automatically
to the Fault mode.
F0007
LOC
FAULT
FWD
Fault mode (p. 101)
After reset the panel returns to
the previous display.
key, you return to the previous operation level without saving the made
LOC
Hz
PAr S
LOC
PAr L
LOC
PArCh
LOC
Main menu
rEF
MENU
FWD
Reference mode (p. 50)
MENU
FWD
Short Parameter mode (p. 51)
MENU
FWD
Long Parameter mode (p. 51)
MENU
FWD
Changed Parameters mode (p. 51)
and
arrow keys until
key.
Fault
tracing).
Control panel
45
Hide quick links:
Advertisement
Table of Contents
