Sony CDX-R3300 Installation/Connections
Car audio: fm/am compact disc player
Hide thumbs
Also See for CDX-R3300:
- Operating instructions manual (134 pages) ,
- Service manual (46 pages) ,
- Installation and connections (4 pages)
Advertisement
Available languages
Available languages
FM/AM
Compact Disc
Player
Installation/Connections
Installation/Connexions
CDX-R3300
CDX-R3000
© 2004 Sony Corporation
1
1
2
4
5
Equipment used in illustrations (not supplied)
Appareils utilisés dans les illustrations (non fournis)
Front speaker
Haut-parleur avant
Rear speaker
Haut-parleur arrière
3-261-846-11 (1)
Printed in Korea
3
4
2
Active subwoofer
Caisson de graves actif
Power amplifier
Amplificateur de puissance
2
A
B
AUDIO OUT REAR
Cautions
• This unit is designed for negative ground 12 V
DC operation only.
• Do not get the leads under a screw, or caught
in moving parts (e.g. seat railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
• Run all ground leads to a common ground
point.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
• The use of optical instruments with this
product will increase eye hazard.
Notes on the power supply lead (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit's rating must be higher than the sum of
each component's fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
• The numbers in the list are keyed to those in
the instructions.
• The bracket 1 and the protection collar 3 are
attached to the unit before shipping. Before
mounting the unit, use the release keys 5 to
remove the bracket 1 and the protection collar
3 from the unit. For details, see "Removing
the protection collar and the bracket (4)" on
the reverse side of the sheet.
• Keep the release keys 5 for future use as
they are also necessary if you remove the
unit from your car.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
1
Catch
Note
Before installing, make sure that the catches on
both sides of the bracket 1 are bent inwards 2 mm
(
3
/
in). If the catches are straight or bent outwards,
32
the unit will not be installed securely and may spring
out.
Connection example (2)
Notes (2-B)
• Be sure to connect the ground lead before
connecting the amplifier.
• If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
Connection diagram (3)
1
To a metal surface of the car
First connect the black ground lead, then
connect the yellow and red power input leads.
2
To the power antenna control lead or power
supply lead of antenna booster amplifier
Notes
• It is not necessary to connect this lead if there
is no power antenna or antenna booster, or
with a manually-operated telescopic antenna.
• When your car has a built-in FM/AM antenna in
the rear/side glass, see "Notes on the control
and power supply leads."
3
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.
4
To the +12 V power terminal which is energized
in the accessory position of the ignition key
switch
Notes
• If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energized at all times.
Be sure to connect the black ground lead to a
metal surface of the car first.
• When your car has a built-in FM/AM antenna in
the rear/side glass, see "Notes on the control
and power supply leads."
5
To the +12 V power terminal which is energized
at all times
Be sure to connect the black ground lead to a
metal surface of the car first.
Advertisement
Related Manuals for Sony CDX-R3300
Summary of Contents for Sony CDX-R3300
- Page 1 FM/AM Compact Disc Player Installation/Connections Installation/Connexions CDX-R3300 CDX-R3000 © 2004 Sony Corporation Printed in Korea Equipment used in illustrations (not supplied) Appareils utilisés dans les illustrations (non fournis) Front speaker Haut-parleur avant Rear speaker Haut-parleur arrière 3-261-846-11 (1) Cautions • This unit is designed for negative ground 12 V DC operation only.
- Page 2 from car antenna à partir de l’antenne de la voiture Left Gauche Right Droit Left Gauche Right Droit Notes on the control and power supply leads • The power antenna control lead (blue) supplies Précautions +12 V DC when you turn on the tuner. •...
- Page 3 Orient the release key correctly. Orientez correctement la clé de déblocage. 1 8 2 5 3 m TOYOTA max. size 8 mm Dimensions max. 5 8 mm Bracket Support Existing parts supplied with your car Pièces existantes fournies avec la voiture (OFF) Claws Griffes...
- Page 4 Installation de l’appareil dans une voiture japonaise (6) Cet appareil ne peut pas être installé dans certaines voitures japonaises. Consultez, dans ce cas, votre détaillant Sony. Remarque Pour éviter tout dysfonctionnement, utilisez uniquement les vis 2 pour le montage. Retrait et pose de la façade (7) Avant d’installer l’appareil, retirez la façade.