Step 5: Preparing the
Remote
You can control the recorder using the
supplied remote. Insert two R6 (size AA)
batteries by matching the 3 and # ends on
the batteries to the markings inside the
battery compartment. When using the
remote, point it at the remote sensor
recorder.
b
Notes
• If the supplied remote interferes your other Sony
DVD recorder or player, change the command
mode number for this recorder (page 16).
• Use the batteries correctly to avoid possible
leakage and corrosion. Should leakage occur, do
not touch the liquid with bare hands. Observe the
following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an
extended period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid
inside the battery compartment, and insert new
batteries.
• Do not expose the remote sensor (marked
the front panel) to strong light, such as direct
sunlight or a lighting apparatus. The recorder may
not respond to the remote.
• When you replace the batteries of the remote, the
code number and Command Mode may be reset
to the default setting. Set the appropriate code
number and Command Mode again.
Controlling TVs with the
remote
You can adjust the remote's signal to control
your TV.
b
Notes
• Depending on the connected unit, you may not be
able to control your TV with some or all of the
buttons below.
on the
• If you enter a new code number, the code number
previously entered will be erased.
Number
buttons
TV 2 +/–
TV PROG
+/–
1
Hold down the TV [/1 button located
at the bottom of the remote.
Do not press the [/1 button at the top of
on
the remote.
TV/DVD
TV [/1
TV t
15
,continued