Sony HT-SS360 Operating Instructions Manual page 24
Sony home theater system user manual
Hide thumbs
Also See for HT-SS360:
- Operating instructions manual (63 pages) ,
- Specifications (2 pages) ,
- Quick setup manual (2 pages)
Table of Contents
Advertisement
4
Press
to start the
measurement.
Measurement starts in 5 seconds.
While the time is counting down, stand
away from the measurement area to avoid
measurement error.
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Measurement for
Speaker existance
Speaker gain, distance,
frequency response
Subwoofer gain and distance
Note
If "CHK MIC" appears, you cannot perform the
Auto Calibration. Connect the calibration mic, then
restart the Auto Calibration.
Tips
• When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT
SELECTOR on the receiver.
– Change the volume level.
24
US
Display
TONE
T.S.P.
WOOFER
Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Measurement
Display
result
When the
SAVE
measurement
process
completes
properly
When the
ERROR
measurement
XXXX
process fails
2
Press V/v repeatedly to select
the item. Then, press
Item
SAVE
WRN CHK
DIST
LEVEL
EXIT
Note
After "SAVE" is displayed for 50 seconds, the
measurement result is saved automatically,
without the need to save the procedure.
3
Save the measurement result.
Select "SAVE" in step 2.
The measurement results are saved.
Explanation
Proceed to step
2.
See "When
error codes
appear" (page
25).
.
Explanation
Saves the measurement
results and exits the setting
process.
Displays warning
concerning the
measurement results. See
"When you select "WRN
CHK"" (page 25).
Displays the measurement
result for speaker distance.
Displays the measurement
result for speaker level.
Exits the setting process
without saving the
measurement results.
Hide quick links:
Advertisement
Table of Contents
