Installing The Exhaust Guard; Adjusting The Lift Arms - Toro Groundsmaster 3500-D Operator's Manual
Hide thumbs
Also See for Groundsmaster 3500-D:
- Service manual (256 pages) ,
- Operator's manual (68 pages) ,
- Operator's manual (16 pages)
Table of Contents
Advertisement
4
Installing the Exhaust
Guard
CE Models Only
Parts needed for this procedure:
1
Exhaust guard
4
Self-tapping screw
Procedure
1.
Position the exhaust guard around the muffler
while aligning the mounting holes with the holes
in the frame
(Figure
1. Exhaust guard
2.
Secure the exhaust guard to the frame with 4
self-tapping screws
9).
Figure 9
(Figure
9).
5
Adjusting the Lift Arms
No Parts Required
Procedure
1.
Start the engine, raise the cutting units, and
ensure that the clearance between each lift arm
and the floor-plate bracket is 5 to 8 mm (0.18 to
0.32 inch) as shown in
Cutting units removed for clarity
1. Floor-plate bracket
2. Clearance
If the clearance is not in this range, adjust
it as follows:
A.
Back off the stop bolts
g008875
1. Stop bolt
2. Clearance
14
Figure
10.
Figure 10
3. Lift arm
(Figure
11).
Figure 11
3. Lift arm
g031571
g031572
- Quick Links:
- Adjusting the Height of Cut
- Controls
Hide quick links:
Advertisement
Table of Contents
