Nokia 7210 Configuration Manual page 703
Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs
Also See for 7210:
- User manual (185 pages) ,
- Service manual (19 pages) ,
- Schematics (11 pages)
Table of Contents
Advertisement
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Configuration File Location
---------------------------
You must enter the location of configuration
file to be used by TiMOS.
a Compact Flash device, or on the network.
Here are some examples
cf1:/config.cfg
ftp://user:passwd@192.168.1.150/./config.cfg
tftp://192.168.1.150/./config.cfg
No existing Config URL
Press ENTER, or type 'none' for no Config URL.
Config File URL:
Step 9. At the prompt, enter none. The following console output is displayed.
Boot Interface Management
-------------------------
Existing eth-mgmt port settings are:
Step 10. At the prompt, enter edit to change the port settings. The following console
You need to assign an IP address for this port.
The existing eth-mgmt
Enter eth-mgmt
Step 11. At the prompt, enter the port IP address and mask that the device should
In case of an IPv6, the IPv6 address should be
3HE 17358 AAAB TQZZA
The following console output is displayed.
You specified a network location for either the
software or the configuration file. You need to
configure either eth-mgmt or uplinkA or uplinkB ports.
You will be asked to configure the port number, IP(v6) address,
static routes, and VLAN Id in case of uplink ports.
eth-mgmt-port
eth-mgmt-address
10.135.25.36/24
eth-mgmt-address
0
eth-mgmt-route
192.0.0.0/8 next-hop 10.135.25.1
eth-mgmt port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
output is displayed.
The IP address should be entered in standard
dotted decimal form with a network length.
example:
192.168.1.169/24
IP address is 10.135.25.36/24. Press ENTER to keep it.
IP Address (Type 0 if none desired):
use (for example, 10.135.4.172/10). The following console output is
displayed.
entered in standard colon hexadecimal notation
with a prefix length.
example:
3FFE::1/112
Use subject to Terms available at: www.nokia.com
The file can be on
© 2021 Nokia.
Appendix: 7210 SAS Boot Procedures
703
Hide quick links:
Advertisement
Chapters
Table of Contents
