Nokia 7210 Configuration Manual page 521
Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs
Also See for 7210:
- User manual (185 pages) ,
- Service manual (19 pages) ,
- Schematics (11 pages)
Table of Contents
Advertisement
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Description
This command allocates resources for use by SAP egress aggregate policer from the egress-
internal-tcam resource pool. This command limits the total amount of chunks allocated for use
by SAP egress aggregate meter to the value specified by the num-resources parameter.
Note:
The no form of this command specifies that software does not allocate any resources for use
by the SAP egress aggregate policer. If no resources are allocated for use, the software fails
all attempts to enable the configuration of the sap-aggregate-meter command for a SAP.
Default
no egress-sap-aggregate-meter
Parameters
num-resources — Specifies the maximum amount of resources for use by this filter
ipv6-128bit-match-enable
Syntax
[no] ipv6-128bit-match-enable num-resources
Context
configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description
This command allocates maximum resources for use by egress filter policies using ipv6
criteria with 128-bit IPv6 addresses.
The resources cannot be shared with any other egress filter policies that specify other match
criteria. Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Router Configuration Guide for
more information on resource allocation and fields available for use.
3HE 17358 AAAB TQZZA
• The resources in the egress-internal-tcam resource pool are shared with other features
(for example, SAP egress aggregate meter). To assign resources to this feature,
resources may be reallocated from other features by disabling the policies association
with a SAP, and others.
• On the 7210 SAS platforms, some of the Egress ACL match criteria require a minimum
amount of resources greater than 1, to be allocated before the match criteria can be
used. In other words, use of SAP egress aggregate meter is mutually exclusive to use
of egress ACLs with the following match criteria - mac-ipv4 match, ipv6-128bit match,
mac-ipv6-64bit match. All these match criteria require a minimum of 2 resources. SAP
egress aggregate meter and egress ACLs MAC match criteria can be enabled
simultaneously, with each feature sharing the available resources equally among
them.
match criteria.
Values
0 to 2
Default
0
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
521
Hide quick links:
Advertisement
Chapters
Table of Contents
