16. ACCESSORIES......................37 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
The appliance must be connected to the water mains • using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. • If the mains power supply cable is damaged, it must •...
ENGLISH access to the mains plug after the • Do not put flammable products or installation. items that are wet with flammable • Do not touch the mains cable or the products in, near or on the appliance. mains plug with wet hands. •...
Page 6
7. Remove the polystyrene protection from the bottom. 3. Remove the internal film. 8. Pull up the appliance in vertical position. 4. Open the door and remove the polystyrene piece from the door seal and all the items from the drum.
Page 7
ENGLISH 11. Pull out the plastic spacers. 12. Put the plastic caps, that you find in the user manual bag, in the holes. The appliance must be level and stable. A correct adjustment of the appliance level prevents the vibration, noise and the movement of the appliance when in operation.
Page 8
If this occur, close the water tap and contact the authorized service centre to replace the hose. 3.5 Water drainage The drain hose should stay at a height of not less than 60 cm and not more than Make sure that the inlet hose 100 cm.
ENGLISH 5. Without the plastic hose guide: Put Make sure that the drain the drain hose in the spigot and hose end is not immersed in tighten it with a clip. Refer to the the water. There may be a illustration.
Page 10
• The Flecken option pre-treats and water than necessary. stubborn stains optimizing the • The steam as a quick and easy way to effectiveness of the stain remover. refresh the clothes. The gentle steam •...
ENGLISH 5. CONTROL PANEL 5.1 Control panel description 11 10 Programme dial Steam Plus touch button (Plus Display Dampf) Spin reduction touch button (U./Min.) Eco touch button (Eco) Time saving touch button (Zeit • Rinse Hold option Sparen) • Extra Silent option Rinse touch button (Spülen) •...
Page 12
5.2 Display Maximum load indicator. The indicator flashes during the laundry load estimation (refer to ProSense load detection paragraph) . Maximum laundry indicator. It blinks if the laundry amount exceeds the declared load. Door locked indicator. Delay start indicator.
ENGLISH Time saving indicator. Spin speed indicator. Rinse hold indicator. Extra silent indicator. Temperature indicator. The indicator appears when a cold wash is set. 6. KNOB AND BUTTONS When the display shows the indicators 6.1 Ein /Aus , the appliance does not Pressing this button for a few seconds heat the water.
Page 14
The display shows the indicator effectiveness. The door stays locked. The drum turns regularly to reduce creasing. This option is not You must drain the water to unlock available with a the door.
ENGLISH After touching theStart/Pause button, • In case of smaller load, touch this button twice to set an extra quick the display shows the indicator programme. the selected delay time and the appliance begins the countdown. The display shows the indicator This option can also be used 6.8 Spülen to shorten the Dampf...
Page 16
Programme Programme description White cotton and coloured cotton. Normal soil and light soil. Standard programmes for the Energy Label consumption Baumwolle values. According to regulation 1061/2010, the programme Baumwolle at 60 °C and the programme Baumwolle at 40 °C with the option are respectively the «Standard 60°C cot-...
Page 17
ENGLISH Programme Programme description White cotton items. This programme removes micro-organ- isms thanks to a washing phase with the temperature main- Anti-Allergie tained above 60°C for some minutes. This helps in removing germs, bacteria, micro-organism and particles. An additional rinsing phase ensures a proper removal of detergent residues and pollens/allergenic items.
Page 18
Programme Default tempera- Maximum spin speed Maximum ture Spin speed range load Temperature range 40 °C 1400 rpm 8 kg 95 °C - Cold 1400 rpm - 400 rpm Baumwolle 40 °C 1200 rpm 3 kg 60 °C - Cold...
7.2 Woolmark Apparel Care - Company for the washing of wool garments labelled as «hand wash» Green provided that the garments are washed according to the instructions issued by the manufacturer of this washing machine. Follow the garment care label for drying and other laundry instructions.
ENGLISH comes on/goes off above the indicator. 9. BEFORE FIRST USE 1. Make sure that all transit bolts have 5. Set and start a programme for cotton been removed from the appliance. at the highest temperature without 2. Make sure that the electrical power is any laundry in the drum.
Page 22
10.3 Filling the detergent and additives 3. To use powder detergent, turn the flap up. Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Maximum level for quantity of liquid additives.
Page 23
ENGLISH With the flap in the In case a selection is not position DOWN: possible, no indicator comes • Do not use on and an acoustic signal gelatinous or thick sounds. liquid detergents. • Do not put more 10.6 Starting a programme liquid detergent than Touch the Start/Pause button to start the the limit shown on in...
Page 24
Changing the delay start after this case, it will be not possible to guarantee the best washing results. the countdown has started About 20 minutes after the To change the delay start: programme start, the 1. Touch the Start/Pause button to programme duration could pause the appliance.
Page 25
ENGLISH 10.10 Interrupting a 3. Close the door and touch the button Start/Pause. programme and changing the The programme or the delay start options continues. When the programme is running, you 10.13 End of the programme can change only some options: When the programme has finished, the 1.
10.15 Stand-by option • The drum still turns at regular intervals to prevent the creases in the laundry. The Stand-by function automatically • The door stays locked. deactivates the appliance to decrease • You must drain the water to open the...
ENGLISH 11.2 Stubborn stains • Use the recommended products for the type and colour of the fabric, the For some stains, water and detergent is programme temperature and the not sufficient. level of soil. We recommend that you pre-treat these 11.4 Ecological hints stains before you put the items in the appliance.
Page 28
12.6 Cleaning the detergent Always follow the dispenser instructions that you find on the packaging of the To prevent possible deposits of dried product. detergent or clotted fabric softener and/or formation of mould in the 12.3 Maintenance wash detergent dispenser drawer, once in a...
Page 29
ENGLISH WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to clean the pump: 1. Open the pump cover. 4.
Page 30
5. When the bowl is full of water, close the drainage duct back and empty the container. 6. Repeat the steps 4 and 5 until the water stops to flow out. 11. Put the filter back into the special guides by turning it clockwise.
Page 31
ENGLISH 12.8 Cleaning the inlet hose and the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1. Remove the inlet hose from the tap and clean the filter.
13. TROUBLESHOOTING WARNING! Refer to Safety chapters. 13.1 Introduction The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre.
Page 33
ENGLISH Problem Possible solution The appliance does not Make sure that the water tap is open. fill with water properly. Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. Make sure that the water tap is not clogged.
Page 34
Problem Possible solution Make sure that the washing programme is finished. Set the drain or the spin programme if there is water in the drum. Make sure that the appliance receives electrical power. This problem may be caused by a failure of the appliance.
ENGLISH Before opening the door: To open the door, proceed as follows: 1. Press the Ein /Aus button to switch CAUTION! the appliance off. Risk of burns! Make sure 2. Disconnect the mains plug from the that the water mains socket. temperature is not too 3.
Programmes Load Energy Water Approxi- Remain- (kg) consump- consump- mate pro- ing mois- tion (kWh) tion (litre) gramme ture (%) duration (minutes) Standard cotton programmes 0.49 Standard 60°C cotton 0.38 Standard 60°C cotton 0.34 Standard 40°C cotton 1) At the end of spin phase.
The tumble dryer can be stacked on the top of the washing machine only by www.aeg.com/shop or from using the correct stacking kit authorised dealer manufactured and approved by AEG. Only appropriate Verify the compatible accessories approved by stacking kit by checking the AEG ensure the safety depth of your appliances.
Page 38
17. ENVIRONMENTAL CONCERNS marked with the symbol with the Recycle the materials with the symbol household waste. Return the product to Put the packaging in applicable your local recycling facility or contact containers to recycle it. Help protect the your municipal office.