When you press any of these buttons, the
orange frame appears on the LCD screen.
Select a desired button or an item with
/
/
/
, then press ENTER to enter.
Notes
Remove the insulation sheet before using the
Wireless Remote Commander.
Insulation sheet
Point the Wireless Remote Commander
towards the remote sensor to operate your
camcorder (p. 7).
When no commands have been sent from the
Wireless Remote Commander within a certain
period, the orange frame disappears. When
/
/
you press any of
the frame appears at the position where it was
displayed last.
You cannot select some buttons on the LCD
screen using
/
/
/
.
To change the battery of the Wireless
Remote Commander
While pressing on the tab, inset your fingernail
into the slit to pull out the battery case.
Place a new battery with the + side facing up.
Insert the battery case back into the Wireless
Remote Commander until it clicks.
Tab
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
When the lithium battery becomes weak, the
operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
/
, or ENTER again,
Screen indicators
Upper left
Bottom
Upper left
Indicator
60 min
Center
Indicator
[STBY]/[REC]
Upper right
Indicator
Center
Upper right
Meaning
MENU button (11)
AUDIO MODE (82)
Self-timer recording (85)
GPS tracking status (34)
Flash (86)/
REDEYE REDUC (86)
MICREF LEVEL low (82)
WIDE SELECT (84)
BLT-IN ZOOM MIC (82)
Remaining battery
Return button (12)
Meaning
Recording status (25)
Photo size (85)
Slide show set (46)
NightShot (31)
Warning (108)
Playback mode (37)
Meaning
Recording image quality
(HD/SD) and recording
mode (FH/HQ/SP/LP)
(78)
Recording/playback/
editing media (68)