Table of Contents
Related Manuals for GE DNCD450EAWC
Summary of Contents for GE DNCD450EAWC
- Page 1 Safety Information Operating Instructions Troubleshooting Tips Consumer Support Write the model and serial numbers here: Model # ______________ Serial # ________________ Owner’s Manual Model: Type 450 175D1807P537 49-90269 12-05 JR...
-
Page 2: For Your Safety
Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or LP fuels. Properly adjusted dryers will minimize incomplete combustion. Exposure to these substances can be minimized further by properly venting the dryer to the outdoors. -
Page 3: Proper Installation
PROPER INSTALLATION This dryer must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions sheet, visit our Website at: ge.com. s Properly ground dryer to conform with all governing codes and ordinances. - Page 4 IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. WARNING! WHEN USING YOUR DRYER s Never reach into the dryer while the drum is moving. Before loading, unloading or adding clothes, wait until the drum has completely stopped. s Clean the lint filter before each load to prevent lint accumulation inside the dryer or in the room.
- Page 5 See the Loading and Using the Dryer section. s If yours is a gas dryer, it is equipped with an automatic electric ignition and does not have a pilot light. DO NOT ATTEMPT TO LIGHT WITH A MATCH.
-
Page 6: About The Control Panel
About the control panel. Your new dryer offers the convenience of starting your dryer loads by simply choosing a Clothes Care Selection and the Heat Setting. Then all you have to do is press START. • Clean lint filter Model Type 450 NOTE: Any time you make a selection that is incompatible with the chosen dry cycle, the dryer will beep twice. - Page 7 This means the dryer is continuously monitoring the amount of moisture in the load. The racetrack lights will continue until the dryer senses a low level of moisture in the load. At that point, the dryer will calculate and display the approximate time remaining.
-
Page 8: About Reversing The Door
(where you removed the filler plugs). Apply firm pressure to get the screw started in untapped holes. Loosen top screw from each hinge on the dryer face half way. With one hand holding the top of the door and the other hand holding the bottom, remove the door from the dryer by lifting it UP and OUT. -
Page 9: Fabric Care Labels
Do not add fabric softener sheets once the load has become warm. They may cause fabric softener stains. Bounce ® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer’s instructions. Do not overload. This wastes energy and causes wrinkling. -
Page 10: Venting The Dryer
Venting the dryer. For the best drying performance the dryer needs to be properly vented. The dryer will use more energy and run longer if it is not vented to the below specifications. Carefully follow the details on Exhausting in the Installation Instructions. -
Page 11: Operation
Dryer may be sitting unevenly Inconsistent drying times Type of heat No numbers displayed Dryer is continuously monitoring • This is normal. When the dryer senses a low level of during cycle, only the amount of moisture in “racetrack” lights... - Page 12 Greasy spots on clothes Improper use of fabric softener Drying dirty items with clean ones • Use your dryer to dry only clean items. Dirty items can Clothes were not completely clean • Sometimes stains which cannot be seen when the...
- Page 13 You can rest easy, knowing that all your valuable household products are protected against expensive repairs. Place your confidence in GE and call us in the U.S. toll-free at for more information. *All brands covered, up to 20 years old, in the continental U.S.
-
Page 14: Serial Number
Check here if you do not want to receive communications from GEA’s carefully selected partners. FAILURE TO COMPLETE AND RETURN THIS CARD DOES NOT DIMINISH YOUR WARRANTY RIGHTS. For information about GEA’s privacy and data usage policy, go to ge.com and click on “Privacy Policy” or call 800.626.2224. Read your Owner’s Manual carefully. -
Page 15: What Is Not Covered
This warranty is extended to the original purchaser and any succeeding owner for products purchased for commercial use within the USA. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location for service. -
Page 16: Consumer Support
Caution must be exercised, since improper servicing may cause unsafe operation. Contact Us If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations Register Your Appliance Register your new appliance on-line—at your convenience! Timely product registration will allow for...