Toro 08733 Installation Instructions

Spring tine toolbar for sand pro and infield pro 3040 and 5040 traction units

Download this manual

Spring Tine Toolbar

Sand Pro

Model No. 08733—Serial No. 260000001 and Up

Important: The traction unit must be equipped with the Mid-mount Toolbar System, Model 08731,

before installing this attachment.

Safety

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of

potential danger. Replace any decal that is damaged or lost.

1. Do not step here.

8111 Lyndale Avenue South

Bloomington, MN 55420

and Infield Pro

93-6687

3040 and 5040 Traction Units

Form No. 3354-287 Rev C

Installation Instructions

Original Instructions (EN)

Printed in the USA.

Page 1 Sand Pro ® and Infield Pro ® 3040 and 5040 Traction Units Model No. 08733—Serial No. 260000001 and Up Installation Instructions Important: The traction unit must be equipped with the Mid-mount Toolbar System, Model 08731, before installing this attachment. Safety...
Page 2 Installation 3. Replace the pivot tube bracket with a saddle bracket and secure it to the frame with the bolts and nuts previously removed (Figure 2). 4. Repeat steps 2 through 3 for the other end of the pivot tube. 5.
Page 3 Figure 2 1. Saddle bracket 2. Guard 3. Extension spring 4. Pivot bracket 8. Install the toolbar into the mid-mount toolbar system saddles as described in step 6 in the Mid-mount Toolbar System Installation Instructions. 9. When finished, hook the long end of the extension spring to the tab on the tool bar spring bracket (Figure 2).
Page 4 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisﬁ ed with your Distributor’s service or have difﬁ...