Page 1
Ver 1.1 2001. 06 HCD-G202 AEP Model UK Model E Model Australian Model HCD-C20 HCD-C20/G202 is the tuner, deck, CD and amplifier section in MHC-C20/G202. Photo: HCD-C20 (AEP model) Model Name Using Similar Mechanism CD Mechanism Type SECTION Base Unit Type...
Page 2
LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY. — 2 —...
TABLE OF CONTENTS SERVICING NOTE 1. GENERAL ................4 NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK OR BASE UNIT 2. DISASSEMBLY 2-1. CD Door ................5 The laser diode in the optical pick-up block may suffer electrostatic 2-2. CD Mechanism Deck ............5 break-down because of the potential difference generated by the 2-3.
SECTION 2 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. 2-1. CD DOOR CD door Two craws 1 Pull out the CD tray and remove the CD door with releasing claws into the direction of arrow. 2-2. CD MECHANISM DECK 1 Two screws (B3x8) 5 CD mechanism deck 7 Harness...
2-3. FRONT PANEL AND MAIN BOARD 8 Screw (BVTP3x6) 7 Two screws (BVTP3x10) 2 Heat sink cover 1 Three screws 6 Two screws (BVTP2.6x6) (BVTP3x10) !º Screw (BVTP3x10) 4 Connector (CN701) 9 Front panel and Main board 9 Screw (BVTP3x10) HOW TO SET THE POWER CORD 5 Screw...
SECTION 3 SECTION 4 MECHANICAL ADJUSTMENTS ELECTRICAL ADJUSTMENTS Precaution DECK SECTION 0 dB=0.775V 1. Clean the following parts with a denatured alcohol-moistened swab: 1. Demagnetize the record/playback head with a head damagnetizer. record/playback heads pinch rollers 2. Do not use a magnetized screwdriver for the adjustments. erase head rubber belts 3.
Page 10
Tape Speed Adjustment (Deck A) 2. Turn the adjustment screw and check output peaks. If the peaks do not match for L-CH and R-CH, turn the adjustment screw so that outputs match within 2 dB of peak. Procedure: 1. Mode: Playback test tape WS-48B frequency counter...
TUNER SECTION 0 dB=1µV Note: As a FM front end (U1) is difficult to repair if faulty, replace it with new one. (AEP, UK models) AM Tuning Voltage Adjustment DC voltmeter Tuner board (VT) – Procedure: 1. Set the reception frequency of the unit to 530 kHz (10 kHz step) or 531 kHz (9 kHz step).
Page 12
FM Tracking Adjustment FM Tuned Level Adjustment (EXCEPT AEP, UK models) FM RF SSG FM RF SSG oscilloscope 75 Ω coaxial – Carrier frequency : 98 MHz SPEAKER terminal Modulation : AUDIO 1 kHz, 75 kHz FM ANTENNA terminal FM ANTENNA terminal (JK101) deviation (100%) (JK101) : 28 dB (at 75 Ω...
Page 13
SECTION 5 DIAGRAMS RF Level Check 5-1. CIRCUIT BOARDS LOCATION CD SECTION oscilloscope CD DECODER board Note: 1. CD Block is basically constructed to operate without adjustment. Therefore, check each item in order given. TP (RF) 2. Use YEDS-18 disc (3-702-101-01) unless otherwise indicated. CN12 (VC) 3.
Page 14
HCD-C20/G202 5-2. BLOCK DIAGRAMS — TUNER SECTION — (US, CND, E, MY, SP, MX, AUS MODELS) L OUT TU L FM/AM MPX IC102 AM IF JK101 CF104 ANTENNA 10.4MHz CF101 CF102 FM IF L101 T101 FM DET 10.7MHz 10.7MHz RF IN...
HCD-C20/G202 — TUNER SECTION — (AEP, UK models) L OUT TU L FM/AM MPX IC102 R OUT R CH AM IF JK101 CF104 ANTENNA 10.7MHz CF101 CF102 FM IF L101 10.7MHz 10.7MHz FM DET RF IN IF OUT 1 FM IF...
HCD-C20/G202 — CD SECTION — OPTICAL PICK-UP BLOCK DIGITAL SIGNAL PROCESSOR, D/A CONVERTER, DIGITAL FILTER DETECTOR IC04 MIX AMP IC05 NLPWM DIGITAL RF 0 DIGITAL DEMODULATOR INTERFACE CD L FILTER LPWM 1BIT FOCUS/TRACKING SERVO, RF AMP IC01 (1/2) SUB CODE...
HCD-C20/G202 — DECK SECTION — PB L CH1/A TAPE B MUTE HP901 Q209 PB HEAD • R CH is omitted R CH MUTE • Signal path SWITCH REC/PLAY : PB (DECK A) Q216 EQ AMP CH1/B IC201 : PB (DECK B)
HCD-C20/G202 — MAIN SECTION — (US, CND, E, MY, SP, MX, AUS models) INPUT SELECTOR L.P.F POWER AMP IC401 RL501 IC403 IC501 LINE AMP JK501 Q451 SPEAKER TU L STANDBY OVERLOAD TUNER MUTE CONTROL ELECTRICAL CONTROL Q501 - Q503 VOLUME...
HCD-C20/G202 — MAIN SECTION — (AEP, UK models) INPUT SELECTOR POWER AMP IC303 IC301 R-CH JK302 LINE AMP PHONES Q305 TU L JK301 ELECTRICAL CONTROL SPEAKER VOLUME MUTE TUNER Q303 SECTION LED601 STEREO (Page 18) DBFB MUTE BASS POWER ON...
HCD-C20/G202 — POWER SECTION — (AEP, UK models) — POWER SECTION — (US, CND, E, MY, SP, MX, AUS models) PT302 POWER TRANSFORMER +5V REG +10.5V REG +11.5V REG RECT +10.5V Q321 Q315 D310-D313 MUTE REG CONTROL CONTROL PT302 POWER...
Page 21
PHD2 PHD1 TOG1 BAL1 TOG2 BAL2 – – TOG3 BAL3 FE AMP – – – FDFCT RF M – – RF O – – RF I – – FE O – FE M SRCH – – FSET • F SET TA M IN4B BIAS IN...
SECTION 6 EXPLODED VIEWS NOTE: The components identified by • For detailed German, East European and CIS model • -XX, -X mean standardized parts, so they may have mark ! or dotted line with mark refer to AEP mode. some difference from the original one. ! are critical for safety.
Ver 1.1 2001.06 6-4. CASSETTE MECHANISM DECK SECTION 2 not supplied not supplied M901 SW202 not supplied HE901 SW203 HRP901 supplied not supplied SW204 not supplied HP901 not supplied not supplied not supplied Ref. No. Part No. Description Remark Ref. No. Part No.
Ver 1.1 2001.06 6-7. BASE UNIT SECTION (KSM-213BCM) not supplied M102 M101 Les composants identifiés par The components identified by mark ! or dotted line with mark une marque ! sont critiques pour ! are critical for safety. la sécurité. Replace only with part number Ne les remplacer que par une specified.
AC SUPPLY SECTION 7 CD DECODER ELECTRICAL PARTS LIST Note: • CAPACITORS • Due to standardization, replacements in the parts list The components identified by uF : µ F may be different from the parts specified in the mark ! or dotted line with mark •...
Page 62
HCD-C20/G202 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2001.06...