Advertisement
3. Lift the intrusion switch module out of the system.
Figure 32. Removing the intrusion switch module
Next steps
Replace the intrusion switch
Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4. Disconnect the system power cable from the system board.
Steps
1. Align and insert the intrusion switch module into the slot on the system until firmly seated.
2. Using the Phillips #1 screwdriver, tighten the screw securing the intrusion switch module.
3. Connect the intrusion switch cable to the connector on the system board.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
module.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
45
Advertisement
