Asus P5GC MX 1333 - Motherboard - Micro ATX User Manual page 39
User manual
Hide thumbs
Also See for P5GC MX 1333 - Motherboard - Micro ATX:
- User manual (8 pages) ,
- User manual (44 pages)
Table of Contents
Advertisement
2.
IDE connectors (40-1 pin PRI_IDE)
The onboard IDE connectors are for Ultra DMA 100/66/33 signal cables.
There are three connectors on each Ultra DMA 100/66/33 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
P5GC-MX/1333
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
ASUS P5GC-MX/1333
IDE Connector
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode
Cable
of device(s)
connector
-
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
1-27
Hide quick links:
Advertisement
Table of Contents
