Replacing The Scsi Backplane; Scsi Backplane Removal And Replacement - HP rp4410 Service Manual
User service guide, fifth edition - hp 9000 rp4410/4440
Hide thumbs
Also See for rp4410:
- Installation manual (103 pages) ,
- Manual (51 pages) ,
- Programmer's manual (109 pages)
Table of Contents
Advertisement
12. Push the SCSI backplane away from the disk drive cage and lift it up and out of the chassis.
Figure 6-50 SCSI Backplane Removal and Replacement
Replacing the SCSI Backplane
To replace the SCSI backplane, follow these steps:
1.
Replace the SCSI backplane to the rear of the disk drive cage.
2.
Turn the swivel latch on top of the hot-pluggable hard disk drive cage to latch the SCSI
backplane to the cage.
3.
Replace the two hot-pluggable disk drives into the disk drive cage. See
Drives" (page
4.
Plug the SCSI backplane-to-midplane cable back into the SCSI backplane.
5.
Plug the internal SCSI cables into the SCSI back plane.
6.
Replace the processor extender board. See
(page
162).
7.
Replace the memory extender board. See
8.
Replace the front cover. See
9.
Replace the front bezel. See
212).
"Replacing the Front Cover" (page
"Replacing the Front Bezel" (page
"Replacing the Processor Extender Board"
"Replacing the Memory Extender Board" (page
"Hot-Pluggable Disk
153).
152).
SCSI Backplane
156).
215
Advertisement
Table of Contents
Troubleshooting
