Dear customer
Thank you for purchasing this product.
Before connecting, operating or adjusting this product, please read the instructions completely.
Please keep this manual for future reference.
These instructions are applicable to the following systems.
System
SC-EN37
Main unit
SA-EN37
SB-EN37
Speakers
SB-EN37A
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the
problem, consult your dealer for instructions.
No play.
MP3 cannot be read.
Sound is unfixed, reversed or comes
from one speaker only.
No sound or there is a lot of noise.
Humming heard during play.
A beat sound or noise is heard while
receiving a radio broadcast.
A low hum or noise is heard during AM
broadcasts.
The picture on the television near the
set disappears or stripes appear on the
screen.
Remote control doesn't work.
Display
--:--
PGM FULL
NO PLAY
ERROR
F76
iPod
iPod does not turn on.
No sound is coming from the speakers.
Music is distorted or the sound level is
too low.
Cannot control the iPod from the CD
Stereo System.
iPod does not charge.
Matsushita Electric Industrial Co., Ltd.
Web Site: http://panasonic.net
Note
"EB" on the packaging indicates the United Kingdom.
•
The disc isn't correctly set.
•
The disc is scratched or dirty. (Tracks skipped.)
•
There is moisture on the lens. Wait for about an hour and then try again.
•
You may not be able to play MP3 if you have copied a multi-session disc that has no data between sessions.
•
When creating a multi session disc, it is necessary to close the session.
•
The amount of data on the disc is too small. Set the amount of data to greater than approximately 5 MB.
•
Check the speaker connections. (➡ page 3)
•
Noise may occur when playing MP3 if recording quality is poor.
•
Keep this unit away from mobile telephones if the interference is apparent.
•
Turn the volume up.
•
Switch the unit off, determine and correct the cause, then switch the unit on. Causes include shorting of the positive and
negative speaker wires, straining of the speakers through excessive volume or power, and using the unit in a hot environment.
•
An AC mains lead or fluorescent light is near the cords. Keep other appliances and cords away from this unit's cables.
•
Switch the TV or other audio player off or separate it from the unit.
•
Switch off the portable audio player connected to "MUSIC PORT".
•
Keep the antenna away from other cables and cords.
•
Keep the AM antenna away from the unit.
•
The location and orientation of the antenna are incorrect.
•
The television antenna wire is too close to the unit. Separate the antenna wire of the television from the unit.
•
Check that the batteries are inserted correctly. (➡ page 2)
•
Replace the batteries if they are worn.
•
You plugged the AC mains lead in for the first time and there was a power failure recently. Set the time. (➡ page 6)
•
The number of programmed tracks is limited to 24. No further tracks can be programmed.
•
A CD-ROM disc that is not CD-DA or MP3 format is inserted. It cannot be played.
•
Incorrect operation performed. Read the instructions and try again.
•
There is a power supply problem. Consult the dealer.
•
Verify that the iPod battery is not depleted by attempting to turn it on without connecting it to the CD Stereo System.
•
Turn off both your CD Stereo System and iPod before inserting it to the Dock. Power on the CD Stereo System and select the
appropriate source.
•
The iPod is not correctly seated into the Dock. Turn off the iPod, remove it from the Dock connector. Reseat it and turn it on
again.
•
Make sure that iPod is actually playing something.
•
Adjust the volume.
•
Check and make sure the equalizer function of your iPod is turned OFF .
•
Make sure the iPod is inserted properly into the Dock.
•
Check the Dock connection and make sure that OPTION port is selected as the source of music. (➡ page 5)
•
Check all connections. (➡ page 3)
Operating Instructions
CD Stereo System
SC-EN37
Model No.
EG EB
RQTV0229-1B
H0307FL1047
En