Advertisement
Quick Links
Location of controls
HYPER TREBLE
FUNCTION
MEGA BASS
VOLUME
OPR/BATT
2
MIC
PAUSE STOP/EJECT
PLAY
REC
FWD ONLY
BAND
DIR
FINE TUNE
TUNE
MODE
FWD/REV indicator
Listening to the radio
1
Set FUNCTION to RADIO.
FUNCTION
RADIO
TAPE (RADIO OFF)
2
Set BAND to the band you want.
FM
FM
SW
SW1
MW
SW2
LW
MW
BAND
BAND
CFS-B7LMK2
CFS-B7SMK2
3
Tune to the station you want.
TUNE
To tune in an SW
band, use FINE
TUNE for better
FINE TUNE
reception.
To turn off the radio
Set FUNCTION to TAPE (RADIO OFF) .
To improve broadcast reception
Reorient the aerial for FM. Reorient the player
itself for MW/LW. For SW, pull the aerial
vertically.
FM
MW/LW
SW
Tips
• To listen through headphones, connect the
headphones to the 2 (headphones) jack.
•For best results, place the player away from a TV.
Use TYPE I (normal) tape only.
Playing a tape
1
Set FUNCTION to TAPE (RADIO
OFF) .
FUNCTION
RADIO
TAPE (RADIO OFF)
2
Insert a recorded tape.
With the side you want
to play facing you.
STOP/EJECT
3
Press 9 PLAY.
PLAY
To
Press
p6 STOP/EJECT
stop playback
fast-forward or
0 or )
rewind the tape
P PAUSE
pause playback
Press this button again to
resume playback.
switch playback to
DIR
the opposite side
To adjust the bass and treble
Turn MEGA BASS toward MAX to enhance the low
tones, and turn HYPER TREBLE toward MAX to
enhance the treble tones.
Tips
• The FWD/REV indicator shows the side being
played during playback: FWDª (the side facing
you), or REV· (the reverse side).
• Set MODE to A to play either side, or d to play
both sides repeatedly.
Recording
1
To record from the radio
Tune to the station you want.
To record from the built-in microphone
(MIC)
Set FUNCTION to TAPE (RADIO OFF) .
2
Insert a blank tape.
With the side you want
to record on facing you.
STOP/EJECT
3
Make sure the FWDª indicator is
highlighted.
If the REV· indicator is highlighted
instead, press the DIR lever to switch
the highlight to FWDª.
REV
FWD
DIR
Note
The player cannot record from the
reverse side of the tape (REV·).
4
Press r REC.
9PLAY is depressed automatically.
PLAY
REC
FWD ONLY
Use TYPE I (normal) tape only.
To
Press
stop recording
p6 STOP/EJECT
pause recording
P PAUSE
Press this button again to
resume recording.
Tips
• For best results, use the AC power source (mains).
• Adjusting the volume or audio emphasis will not
affect the recording level.
Notes
• When r REC is pressed with MODE set to d ,
the MODE setting switches to A automatically.
• When recording from the built-in microphone, the
sound cannot be monitored through the
headphones.
• If the MW or LW programme makes a whistling
sound, set ISS (Interference Suppress Switch) (at
the rear) to the position that most decreases the
noise. Normally set the Switch to "2" (CFS-
B7LMK2 only).
Notes on cassettes
• Break off the cassette tab from side A or B to
prevent accidental recording. If you want to reuse
the tape for recording, cover the tab hole with
adhesive tape.
Side A
Tab for
Tab for
side A
side B
• The use of cassettes with more than 90 minutes of
play time is not recommended except for long,
continuous recording or playback.
Advertisement
Related Manuals for Sony CFS-B7LMK2
Summary of Contents for Sony CFS-B7LMK2
-
Page 1: Playing A Tape
• If the MW or LW programme makes a whistling BAND STOP/EJECT BAND sound, set ISS (Interference Suppress Switch) (at the rear) to the position that most decreases the CFS-B7LMK2 CFS-B7SMK2 noise. Normally set the Switch to “2” (CFS- B7LMK2 only). BAND Make sure the FWDª indicator is Notes on cassettes Tune to the station you want. -
Page 2: Troubleshooting
If you have any questions or OPR/BATT indicator lights up. used, remove them to avoid problems concerning your player, damage that can be caused by please consult your nearest Sony battery leakage or corrosion. dealer. • The nameplate indicating operating voltage, power to AC IN consumption, etc., is located on the...