Presetting Radio Stations - Sony HT-SF2300 Operating Instructions Manual
Hide thumbs
Also See for HT-SF2300:
- Operating instructions manual (76 pages) ,
- Quick setup manual (2 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
PRESET
+/-
3,5
1
4
You can preset up to 30 FM stations and 30
AM stations. Then you can easily tune in the
stations you often listen to.
Presetting radio stations
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune in the station that you
want to preset using automatic
tuning (page 49) or direct
tuning (page 50).
Switch the FM reception mode, if
necessary (page 49).
3
Press MEMORY.
"MEMORY" lights up for a few seconds.
Perform steps 4 and 5 before
"MEMORY" goes out.
1
2
'-----4
3
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
2
Press D.TUNING.
3
Press the numeric buttons to
enter the frequency.
Example l: FM 102.50 MHz
Select 1 .. 0 .. 2 .. 5 .. 0
Example 2: AM 1,350 kHz
Select 1 .. 3 .. 5 .. 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
4
Press ENTER.
50
G8
Hide quick links:
Advertisement
Table of Contents
