Preset tuning (continued)
Presetting
radio
stations
1 Rotate FUNCTION to select TUNER.
The last received station is tuned in.
2 Tune in the station that you want to
preset using Direct Tuning (page 38) or
Automatic Tuning (page 39).
3
Press MEMORY.
"MEMORY"
appears in the display for a
few seconds.
Do steps 4 to 6 before "MEMORY"
goes
out.
4
Press SHIFT to select a memory page
(A, El or C).
Each time you press SHIFT, the letter "A",
"B", or "C" appears in the display.
5 Press PRESET TUNING + or PRESET
TUNING -to select a preset number.
If "MEMORY"
goes out before you press
the preset number, start again from step 3.
6
Press MEMORY again to store the
station.
If "MEMORY"
goes out before you press
the preset number, start again from step 3.
7 Repeat steps 2 to 8 to preset another
station.
To change
a preset
number
to
another
station
Do steps 1 to 6 to preset a new station to the
number.
Tuning
to preset
stations
You can tune the preset stations by either of the
following two ways.
Scanning
the
preset
stations
1
Rotate FUNCTION to select TUNER.
The last received station is tuned in.
2 Press PRESET TUNING + or PRESET
TUNING - repeatedly
to select the
preset station you want.
Each time you press the button, the receiver
tunes in one preset station at a time, in the
corresponding order and direction as
follows:
Using
the
preset
codes
Use the supplied remote to perform the
following operations. For details on the buttons
used in this section, see the operating
instructions for the supplied remote.
1
Rotate FUNCTION to select TUNER.
The last received station is tuned in.
2 For remotes without a display:
Press SHIFT to select a memory page
(A, B, or C), then press the preset
number of the station you want using
the numeric buttons.
For remotes with a display:
Select the preset station you want from
the list displayed
on the supplied
remote.
40