Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service or repair the product or products dealt within this service information by anyone else could result in serious injury or death. AL718...
1500 ohm resistor and 0.15uF capacitor. 4-4 Move the resistor connection to each exposed metallic part and measure the voltage. 4-5 Reverse the polarity of the AC plug in the AC outlet and repeat the above measurement. AL718...
The product has 26 memory mode in total . 16 modes are preset and 10 modes are user definable. 2.7 Fine dot pitch LCD panel with a fine dot pitch ( Horizontal : 0.264 mm / Vertical : 0.264 mm) AL718...
< 20 ms (Tr+Tf) + 5V (for DDC) View angle 75/75/65/60 degrees Sync GND Color coordinate x=0.313,y=0.329 None DDC Data 4. CONNECTORS Horizontal Sync 4.1 AC power cord : CEE22 typed connector 4.2 Audio cable Vertical Sync DDC Clock AL718...
Page 9
H/V Separate : TTL level this LCD display can automatically function with 5.5.3 Input impedance a certain position. Horizontal: Sync frequency : 30~81 kHz Video input : 75 ohms Vertical : Sync frequency : 56~75Hz Sync input : > 1 k ohms AL718...
Page 10
Contrast : Maximum B: Full white pattern > 50,000 hours (demonstrated MTBF) Brightness : min 11.2 MTBF for LCD A: Full black pattern The brightness is still more than 50% of the Brightness : max original brightness after 30,000 hours (min.) AL718...
On-Chip Microcontroller (OCM) The gm2120 on-chip microcontroller(OCM) serves as the system microcontroller.That is , it programs the gm2120 and manages other devices in the system such as the keypad, the backlight, LED, audio and non-volatile RAM.using general purpose input/output (GPIO) pins. AL718...
Page 12
LVDS link. At a transmit clock frequency of 85 MHz, 24 bits of RGB data and 3 bits of LCD timing and control data ( FPLINE, FPFRAME, DRDY) are transmitted at rate of 595 Mbps per LVDS data channel. U1 AS the ODD pixel transmitter , U2 as the EVEN pixel transmitter. AL718...
Page 13
Pin 4 ---------> GND Pin 5 ---------> Vdc Output ( 2.5V +/- 5%) Pin 6 ---------> GND Pin 7 ---------> On /Off ( "High" set Lamp on ) Pin 8 ---------> NA Pin 9 ---------> Brightness Voltage Pin 10 --------> Audio Volume AL718...
Page 14
Pin 2 ---------> Speaker left2 Pin 3 ---------> Speaker right1 Pin 4 ---------> Speaker right2 CN201 ~ CN204 ; Pin 1 ---------> HV ( High Voltage for CCFL ) Pin 2 ---------> Return ( Low Voltage for CCFL ) AL718...
Page 16
5.2 Disassembly 5.2.1 Stand base& rear cover removal 1.remove the two screws "1"from neck 2.remove the base 3. remove the real cover 5.2.2. PCB holder removal 1.slide the pcb holder from the panel model 2.remove the pcb holder AL718...
Page 17
5.2.3. Panel module removal 1) remove four screws "4,5" 2) remove the Panel module AL718...
There are some OSD menus defined in this system ♦ Main Menu ♦ Volume menu ♦ Prompt menu More detail descriptions are listed bellows: 6.2.1 Main Menu There are 5 sub functions in main menu. The selected function icon will show in red in AL718...
Page 19
+ or -Key and press Select key to enter the sub function. * Brightness/Contrast Function Selec * Tracking Function Selec * Position Function Selec * Color Function Selec * Other Function AL718...
Page 20
Brightness/Contrast, Tracking, Position, Color and Other The Select button can enter function adjustment and goto next step. The Menu button can back to OSD-OFF. Step 2: – To use button to select the item to be adjusted. AL718...
Page 21
The Select or Menu button is to finish adjustment and then back to Step 2. 6.3.2 Volume Menu Operation – to adjus t Volume level and Select to toggle mute on/off. Menu to quit Volume adjust operation 6.3.3 OSD Time out The OSD Time out is defined to 20 sec. AL718...
7. NECESSARY EQUIPMENT LIST Item Discription Personal Computer with Windows 98 or above version Luminance Meter Minolta CA 110 Video Gnerator : Chroma 2000,2135,2250 or equivalent Colour Analyzer : Minolta , Chroma or equivalent Watt / Power Meter 10 Times Magnifier AL718...
OB / OG / OR [0..7] DATA VGA RED / GREEN / BLUE GM 2120 TO PANEL LVDS INTERFACE LCDVCC VGA VSYNC / HSYNC PPWR HS / VS Key Control GPIO0 / PWMO GPIO1/PWM1 VOLU Control GPIO 13/12 (NVRAM SCL/SDA) ROM DATA0~7 AT24C16 AT49HF AL718...
Page 35
4501-10-10P-R AUTO/SEL HDK632R-ST RIGHT HDK632R-ST LEFT HDK632R-ST POWER HDK632R-ST orange MENU HDK632R-ST LED1 EL-209-2EGW green AL718 10-8...
Page 38
OK ? Check Connector Change Cable CN2, Cable Check Powe r Module OSD Control CN1 Pin 12 Vo lu me Mute , Volu me & Pin11 Mute Check IC301 ADA7496 Correct ? Change ADA7496 Or Powe r Module AL718 11-3...