Sony SRW-5800 Installation Manual page 11
Hd digital videocassette recorder
Hide thumbs
Also See for SRW-5800:
- Operation manual (211 pages) ,
- Brochure (20 pages) ,
- Operation manual (175 pages)
Table of Contents
Advertisement
. Attaching the outer rails
12. Loosely attach the two outer rails to the middle of the
5U space in the rack for mounting this unit, with the
eight hexagon socket head cap screws, eight flat
washers, and four plate nuts (small).
By 5U
2U
SRW-5800
Plate nut (small)
Rail
Flat washer
Hexagon socket
head cap screw
L-shaped hexagon wrench
13. Check that the two intermediate rails attached to the
rack are parallel.
Hexagon socket
head cap screw
2 pcs
Rear side
Rail bracket fixing screws
Intermediate rails
Rail bracket fixing screws
Front side
Hexagon socket
A = A' = 416 mm
head cap screw
2 pcs
14. As shown in the following figure, adjust each front-
side position of the outer rails on both sides (left and
right) so that the distance from the surface of the rack
to the tip of the rail becomes within the range of 50 to
55 millimeters.
15. To fix the four rail brackets, fully tighten the eight
loosely fitted rail bracket fixing screws (B4 x 8) in
steps 10 and 11.
Tightening torque: 120 x 10
Rack
Rail bracket
50 to 55 mm
Rack angle
16. To fix the two outer rails to the rack, fully tighten the
eight loosely fitted hexagon socket head cap screws in
step 12 using the L-shaped hexagon wrench.
Hexagon socket
head cap screw
2 pcs
A
A'
Hexagon socket
head cap screw
2 pcs
_2
N.m {12.2 kgf.cm}
Outer rail
Rail bracket fixing screws
B4 x 8
1-7 (E)
Advertisement
Table of Contents
