Page 1
* Refer to parts list on page 18. duction of labels on, or inside the product relating to laser product safety. KENWOOD Corp. certifies this equipment conforms to DHHS Regulations No.21 CFR 1040. 10, Chapter 1, subchapter J. Caution : No connection of ground line if disassemble the unit.
RXD-M37 3 7 63 1515 0 ADJUSTMENT SERVICE ADJUSTMENT Lubrication The mechanical parts are factory coated with a thin coat of light grease and should not require further lubrication. If a light grease is applied, be careful not to get any grease on the play/record head or erase head, hubs, pulleys, tapes reels, drive belts, or switches.
Page 5
RXD-M37 3 7 63 1515 0 ADJUSTMENT 2. Insert a 10 kHz test tape (Teac MTT-1141V or Equivalent) into the tape mechanism and play it back. 3. While playing back the test tape, slowly turn the azimuth adjusting screw until the amplitude of both channel output waveforms is maximum and in phase.
Page 6
RXD-M37 3 7 63 1515 0 ADJUSTMENT TUNER ALIGNMENT PROCEDURE Equipment needed: 1. AM Signal generator 2. FM Signal generator 3. DC Voltage meter 4. Oscilloscope 5. Output meter (VTVM) AM Alignment Step S/G Frequency Dial Setting Indicator Adjust Remarks 450 kHz (1 kHz 30% mod.) 612 kHz Connect...
Page 7
RXD-M37 3 7 63 1515 0 ADJUSTMENT FM Alignment: TEST UNIT GROUND METER Figure 6. FM Band Frequency Coverage Alignment Connect FM S/G to ANT inputs (mod 1 kHz 22.5kHz dev.) Step S/G Frequency Dial Setting Indicator Adjust Remarks 87.5 MHz Low end Connect DC voltage L203...
Page 15
Description Ref. No Parts No. ress Parts nation marks nation marks ress Parts ✻ F07-2029-08 ANT TERMI CVR 48-04200-50 RXD-M37-L/M37-S T90-0908-08 AM ANTENNA 23-04910-02 ✻ A70-1690-08 REMOTE CONTROL V-RE-KEN337 ✻ B60-5466-08 INSTRUCTION(E) 88-00337-07 ✻ A70-1691-08 REMOTE CONTROL M-RE-KEN337 ✻ B60-5467-08...
Page 16
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
Page 17
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
Page 18
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
Page 19
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
(For other countries) ...... 530 kHz ~ 1,610 kHz Notes: CD player section • KENWOOD follows a policy of continuous advancements in Laser ........... Semiconductor laser development. For this reason specifications may be changed without Over sampling ..........8 fs (352.8 Hz) notice.