Lang 124T Installation And Operation Instructions Manual
Thermostatic electric griddle
Hide thumbs
Also See for 124T:
- Installation and operation instructions manual (24 pages) ,
- Installation and operation instructions manual (24 pages)
Table of Contents
Related Manuals for Lang 124T
Summary of Contents for Lang 124T
-
Page 1: Electric Griddle
THERMOSTATIC ELECTRIC GRIDDLE Commercial & Marine 124T, 124TC, 124THE, 124TSS 136T, 136TC, 136TNTS 148T, 148TC, 148TSS 160T, 160TC, 160TSS 172T, 172TC, 172TSS Installation and Operation Instructions 2M-W352 Rev. F 10/01/08 IL1552 136T... - Page 2 SAFETY SYMBOL These symbols are intended to alert the user to the presence of important operating and maintenance instructions in the manual accompanying the appliance. FOR YOUR SAFTEY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINTIY OF THIS OR ANY OTHER APPLIANCE.
-
Page 3: Table Of Contents
Exploded View & Parts List ..... 18-23 NOTICE Service on this or any other Lang appliance must be performed by qualifi ed personnel only. Consult your Lang Authorized Service Agent Directory. - Page 4 Volts AC Supply Amp 3 Ph Supply Amp 3 Ph Supply TOT. 1PH. Wire TOT. 1PH. Wire Wire 1 PH 1 PH 3 PH 124T-380VM 380V 50/60 27.3 15.7 15.7 124T-440VM 440V 50/60 23.6 13.6 13.6 124T-480VM 480V 124T-M 208/240V...
-
Page 5: Specifi Cations
SPECIFICATIONS Current Model Volts AC Sply Amp 3 Ph Sply Sply Amp 3 Ph Sply Tot. 1ph. Wire Wire Tot. 1ph. Wire Wire 124T 208/240V 124T-220V 220V 50/60 45.5 39.4 22.7 22.7 124T-220VCW 220V 50/60 45.5 39.4 22.7 22.7 124T-380V 380V 27.3... -
Page 6: Equipment Description
EQUIPMENT DESCRIPTION Griddle Surface Gutter Grease Pan Legs IL1553 Section Temp. Dial Section Pilot Light Exterior Construction The griddle dimensions are 17” (43.18cm) High, 30” (76.20cm) Deep, and width is dependent on the actual model number. The Sides, Bottom, and Rear wall are constructed of double wall stainless steel, which allows closer installation to combustible surfaces. -
Page 7: Unpacking
UNPACKING Receiving the Griddle Upon receipt, check for freight damage, both visible and concealed. Visible damage should be noted on the freight bill at the time of delivery and signed by the carrier’s agent. Concealed loss or damage means it does not become apparent until the merchandise has been unpacked. -
Page 8: Installation
INSTALLATION IL1554 Std Leg Marine Bolt Down Leg Above: typical leg installation. Leg Installation There are four, 4” legs provided for 2, 3 and 4 foot griddles. 2.5” There are eight 4” legs provided for 5 and 6 foot griddles. IL1550 The legs are shipped in the grease drawers of the griddle. -
Page 9: Ventilation & Clearence
148T 1,4,7 2,5,8 3,6,9 1,3,5,7 2,4,6,8 chargeable to Lang Manufacturing 160T #1 1,3,5 2,4,6 Company as warranty. To convert 160T #2 to single-phase have a Lang 172T #1 1,3,5 2,4,6 Authorized Service Agent, follow 172T #2 1,3,5 2,4,6 this chart. -
Page 10: Initial Start-Up
INITIAL START UP Pre-Power On Before starting the griddle for the fi rst time, clean the griddle body and cooking surface. Use a mild soap and water solution, then rinse with clear water and dry. Power On Set the temperature dials to 200°F (93°C). Heat the griddle at 200°F (93°C) for 2 hours to evaporate any moisture that may be in the elements. -
Page 11: Operation
OPERATION General The suggested time and temperature chart (below) is provided as a guide for the products listed only. If different temperature settings are to be used, select one side of the griddle and operate at the lowest temperature. Adjoining sections should be set at progressively higher temperatures. Do not try to operate the end sections hot and the center sections cool. -
Page 12: Cleaning
MAINTENANCE & CLEANING Cleaning • Always start with a cold griddle. • The stainless exterior can easily be cleaned using a good non-abrasive cleaner. • Always follow the cleaner manufacturer’s instructions when using any cleaner. • Always apply these cleaners when the griddle is cold and rub in the direction of the metal’s grain. Griddle Surface Care (non-chromium surfaces) It takes very little time and effort to keep the griddle attractive and performing at top effi... -
Page 13: Crome Surface Griddle Care
GRIDDLE CARE (CHROME SURFACES) (Chrome surface griddles are marked with “CHS” at the end of the model number designation on the nameplate.) It takes very little time and effort to keep this Industrial Chrome griddle surface sparkling clean and performing at top effi... -
Page 14: Troubleshooting
Failed Element have continuity* NOTICE: Service on this, or any other, LANG appliance must be performed by qualifi ed personnel only. Consult your Lang Authorized Service Agent Directory or call the factory at 1-800-807-9054, or WWW.STAR- MFG.COM For the service agent nearest you. - Page 15 TROUBLESHOOTING continued USE OF ANY REPLACEMENT PARTS OTHER THAN THOSE SUPPLIED BY LANG OR THEIR AUTHORIZED DISTRIBUTORS CAN CAUSE BODILY INJURY TO THE OPERATOR AND DAMAGE TO THE EQUIPMENT AND WILL VOID ALL CAUTION WARRANTIES.
-
Page 16: 208/240Vac
12.0 24.0 66.1 66.1 43.3 12-13-02 REV. BY : REV. DATE : CHK. BY : DWN. BY : DWN. DATE : CHK. DATE : LANG GRIDDLE 208-240/220VAC DESCRIPTION: Manufacturing 61114-01 DWG. NO: FROM ACAD SHEET REV: CAD FILE : Company... -
Page 17: 480Vac
LG48 / 148T LG36 / 136T LG24 / 124T 1 GRIDDLE ELEMENTS 2 GRIDDLE PILOT LAMP 3 GRIDDLE THERMOSTAT 4 TERMINAL BLOCK CONN # 2 USE LG24 CONN # 2 USE LG36 SERVICE CONNECTIONS NOTE: LG60 & LG72 HAVE TWO POWER SUPPLY CONNECTIONS... -
Page 18: Exploded View & Parts List
14 10 Model: Electric Thermostatic Griddle SK2397 Rev. - 8/15/08... -
Page 19: Parts List
PARTS LIST September 10, 2008, Rev F Model No: 124T, 124TC, 124THE, 124TSS Selectronic Electric Griddle Part Number Description Number K9-XL-722-2 PLATE ASY 2’ ACU 124T K9-XL-722-21 PLATE ASY 2’ ACU 4.5 124T-480VSJ, 124TSS, 124TSS-480V K9-XL-722-211 PLATE ASSY 2’ ACU WITH 4.5... - Page 20 PARTS LIST October 1, 2008, Rev. F Model No: 136T, 136TC, 136TNTS Thermostatic Electric Griddle Commercial & Marine Part Number Description Number K9-XL-722-3 PLATE ASY 3’ ACU 136T, 136T-440VM, 136T-480V K9-XL-724-34 PLATE ASSY 3’ ACU W/6.75 136TC-TE K9-XL-722-W35 PLATE ASY 3’ ACU-NO TAPER 136TNTS 2N-11030-30 ELMNT GRID 208V 1257W...
- Page 21 PARTS LIST September 10, 2008, Rev. F Model No: 148S, 148S-480V, 148S-SC, 148S-WB Selectronic Electric Griddle Part Number Description Number K9-XL-722-4 PLATE ASY 4’ ACU 148T K9-XL-722-41 PLATE ASY 4’ ACU 4.5 148T-SJ, 148TSS K9-XL-722-44 PLATE ASY 4’ ACU CHRME 3/4H 148TC-TE K9-XL-724-4 PLATE ASY 4’...
- Page 22 PARTS LIST October 1, 2008, Rev. F Model No: 160T, 160T-M 160T-480V, 160TC-TE, 160TSS Selectronic Electric Griddle Part Number Description Number K9-XL-722-5 PLATE ASY 5’ ACU 160T K9-XL-722-51 PLATE ASY 5’ ACU 4.5 160TSS K9-XL-724-54 PLATE ASY 5’ ACU CHRME 3/4” 160TC-TE 2N-11030-30 ELMNT GRID 208V 1257W...
- Page 23 PARTS LIST October 1, 2008, Rev. F Model No: 172T, 172T-PE, 172T-SJ, 172TC, 172TSS Selectronic Electric Griddle Part Number Description Number K9-XL-722-6 PLATE ASY 5’ ACU 172T K9-XL-722-61 PLATE ASY 6’ ACU 4.5 172T-480VSJ, 172T-SJ, 172TSS K9-XL-722-611 PLATE ASY 6’ ACU TALL 172T-PE K9-XL-724-6 PLATE ASY 6’...