Canon imageRUNNER ADVANCE 4551i Service Manual page 436
Hide thumbs
Also See for imageRUNNER ADVANCE 4551i:
- Faq manual (44 pages) ,
- User's manual (notification of new and enhanced functions (40 pages)
Table of Contents
Advertisement
583-8002-02
Detection Description
Remedy
590-0002-02
Detection Description
Remedy
Error in the Tray Auxiliary Guide Motor (Finisher-Y1)
The Front/Rear Tray Auxiliary Guide HP Sensors don't detect the tray auxiliary guides when the
Tray Auxiliary Guide Motor has been driven for 1 second.
STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Front Tray Auxiliary Guide HP Sensor (PS117) to the Finisher Controller
PCB
- Harnesses from the Rear Tray Auxiliary Guide HP Sensor (PS118) to the Finisher Controller PCB
- Harnesses from the Tray Auxiliary Guide Motor (M109) to the Finisher Controller PCB
- Front Tray Auxiliary Guide HP Sensor (PS117)
- Rear Tray Auxiliary Guide HP Sensor (PS118)
- Tray Auxiliary Guide Motor (M109)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the malfunction in the swing guide unit.
2. Check whether there is not the malfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
Error in the Punch (Inner Puncher-C1)
The Puncher does not come on the Punch HP Sensor after driving stopped during initialization.
The Punch HP Sensor does not detect the punch when the Punch Motor has been driven for 0.4
seconds for returning the punch after the punch jam.
[Related parts]
- Harnesses from the Punch HP Sensor 1 (S5) to the Puncher Relay PCB
- Harnesses from the Punch HP Sensor 2 (S6) to the Puncher Relay PCB
- Harnesses from the Punch Motor Clock Sensor (S7) to the Puncher Relay PCB
- Harnesses from the Punch Motor (M2) to the Puncher Relay PCB
- Punch HP Sensor 1 (S5)
- Punch HP Sensor 2 (S6)
- Punch Motor Clock Sensor (S7)
- Punch Motor (M2)
- Puncher Relay PCB (PCB5)
- Puncher Controller PCB (PCB1)
- Finisher Controller PCB (PCB1)
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Puncher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
423
7. Error/Jam/Alarm
Advertisement
Table of Contents
Troubleshooting
