Related Manuals for HP 70909A
Summary of Contents for HP 70909A
- Page 1 Installation Guide HP 70909A and HP 70910A RF Section ABCDE HP Part No. 70909-90002 Printed in USA April 1993...
- Page 2 Notice Restricted Rights Legend.
-
Page 3: Certi Cation
Certi cation Warranty Limitation of Warranty Exclusive Remedies Assistance Product maintenance agreements and other customer assistance agreements are available for Hewlett-Packard products. For any assistance, contact your nearest Hewlett-Packard Sales and Service Oce. -
Page 4: Safety Symbols
Safety Symbols caution Caution caution sign denotes a hazard. It calls attention to a procedure warning which, if not correctly performed or adhered to, could result in injury Warning or loss of life. Do not proceed beyond a sign until the indicated warning conditions are fully understood and met. -
Page 5: General Safety Considerations
General Safety Considerations , make sure it has been properly Before this instrument is switched on Warning grounded through the protective conductor of the ac power cable to a socket outlet provided with protective earth contact. Any interruption of the protective (grounding) conductor, inside or outside the instrument, or disconnection of the protective earth terminal can result in personal injury. -
Page 6: Installation At A Glance
Installation at a Glance... - Page 7 Equipment and documentation supplied HP 71209A Quick Start Guide HP 70909A and HP 70910A Installation Guide Tools needed Antistatic precautions Installation overview...
- Page 8 In This Book HP 70000 Modular Spectrum Analyzer Installation and Veri cation Manual viii...
- Page 9 Contents 1. Installation 2. If you have problems with installation Contents-1...
- Page 10 Figures Tables Contents-2...
-
Page 11: Installation
Installation Tools needed Antistatic precautions HP 70000 Modular Spectrum Analyzer Installation and Veri cation Manual Installation overview Installation... - Page 12 Step 1. Switch o the system's ac line power HP 70000 Modular Spectrum Analyzer Installation and Veri cation Manual Installation...
- Page 13 Step 2. Disconnect the existing RF section's rear panel cables Installation...
- Page 14 Step 3. Remove the existing RF section Installation...
- Page 15 Step 4. Unpack your new RF section HP 70909A and HP 70910A Installation Guide HP 71209A Quick Start Guide Installation...
- Page 16 Step 5. Check or set the HP-MSIB address on your new RF section HP 70000 Modular Spectrum Analyzer Installation and Veri cation Manual Installation...
- Page 17 Step 6. Install your new RF section Installation...
- Page 18 Step 7. Connect the new RF section's rear panel cables Installation...
- Page 19 Step 8. Switch on the system's ac line power Caution Installation...
- Page 20 Step 9. Check proper operation of your new RF section HP 70000 Modular Spectrum Analyzer Installation and Veri cation Manual 1-10 Installation...
- Page 21 If you have problems with installation If you have problems with installation...
- Page 22 If the system's power-on self test fails Figure 2-1. Line Voltage Selector Figure 2-2. Line Fuse Removal and Replacement If you have problems with installation...
- Page 23 If you have problems with installation...
- Page 24 If your RF section is powered on but not responding correctly If you have problems with installation...
- Page 25 If the STATUS ERR indicator LED on your new RF section is ashing If you have problems with installation...
- Page 26 If more than one module's error indicator is ashing If you have problems with installation...
- Page 27 If hardware errors messages occur HP 70909A and HP 70910A Service Guide ROM check error HP 70909A and HP 70910A Service Guide 1st LO unleveled HP 70909A and HP 70910A Service Guide 2nd LO unlocked HP 70909A and HP 70910A Service Guide...
- Page 28 RAM failure YTF drive error HP 70909A and HP 70910A Service Guide Tune+Span error HP 70909A and HP 70910A Service Guide EEPROM check error If you have problems with installation...
- Page 29 If you require additional technical resources Before calling or returning your RF section for service Calling Hewlett-Packard for service If you have problems with installation...
- Page 30 Table 2-1. Hewlett-Packard Sales and Service Oces US FIELD OPERATIONS EUROPEAN OPERATIONS INTERCON OPERATIONS HEADQUARTERS HEADQUARTERS HEADQUARTERS California Australia France Canada Germany Colorado Japan Great Britain Georgia China Illinois New Jersey Singapore Texas Taiwan 2-10 If you have problems with installation...
- Page 31 Returning your equipment for service Caution If you have problems with installation 2-11...
- Page 32 Table 2-2. Packaging and Contents Item Description HP Part Number Qty 2-12 If you have problems with installation...