Step 7: Easy Setup - Sony RDR-GX360 Operating Instructions Manual
Dvd players & recorders: single tray dvd recorder
Hide thumbs
Also See for RDR-GX360:
- Quick start manual (2 pages) ,
- Specification sheet (2 pages) ,
- Service manual (85 pages)
Table of Contents
Advertisement
7
Set the command mode for the remote so it
matches the command mode for the
recorder you set above.
Follow the steps below to set the command
mode on the remote.
A Hold down ENTER.
B While holding down ENTER, enter the
command mode code number using the
number buttons.
Command Mode
DVD1
DVD2
DVD3
C Hold down both the number buttons and
ENTER at the same time for more than
three seconds.
To return to the previous display
Press O RETURN.
To check the command mode for the recorder
Press x (stop) on the recorder when the recorder
is turned off. The command mode for the recorder
appears in the front panel display.
If the command mode for the recorder has not
been changed, set the command mode for the
remote to the default setting of DVD3. If the
command mode for the remote is changed to
DVD1 or DVD2, you will be unable to operate
this recorder.
Code number
number button 1
number button 2
number button 3
Step 7: Easy Setup
Follow the steps below to make the minimum
number of basic adjustments for using the
recorder.
Settings are made in the following order.
OSD Language Setup
m
Cable Box/Sat. Control Setup
m
Clock Setup
m
TV Type Setup
m
Finished!
1
1
2
2
Number
4
4
5
5
buttons
7
7
8
8
0
0
O RETURN
1
Turn on the TV.
2
Press "/1.
The recorder turns on.
"/1
3
3
6
6
9
9
M/m/</,,
ENTER
,continued
23
US
Hide quick links:
Advertisement
Chapters
Table of Contents
