2. Remove the Hard Disk Drive Unit
(1) Remove the two screws and the HDD lid.
(2) Release the three harness holders shown in
the figure.
(3) Disconnect the two SCSI connectors and the
two power harness's connectors from each
hard disk drive.
(4) Disconnect the harness from the connector
CN1 on the SE-378 board.
(5) Remove the nine screws and remove the hard
disk drive unit from the unit in slanting
shown in the figure.
n
Be sure to put the removed hard disk drive
unit on the HDD cushion.
3. Replace the Hard Disk Drive
Refer to Section 5-31-3.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P
http://getMANUAL.com
Screw (B3 x 6)
Screw (B3 x 6)
SCSI connector
Harness holder
SCSI connector
Screws (B3 x 6)
Screws (B3 x 6)
5-31-2. Removal/Installation of Hard Disk Drive
HDD lid
Harness holder
Power harness's
connector
Harness holder
Power harness's connector
Screws (B3 x 6)
Hard disk drive unit
Screws (B3 x 6)
Remove the Hard Disk Drive Unit
CN1
SE-378 board
5-191