Changing The Lens Position For Rear Projection (Optical Axis Angle: 0 Degree) - Sony VPL-PX35 Installation Manual

Hide thumbs Also See for VPL-PX35:

Table of Contents

Available languages

Slide the top cover back until it makes contact

with the rear side.

Tighten the screw (single long screw (M3)) in

the bottom base.

Note

• The lens scratches easily, so when handling it,

always place it gently on a stable and level surface in

a horizonal position.

• Avoid touching the lens surface.

Changing the Lens

Position for Rear

Projection (Optical Axis

Angle: 0 degree)

For rear projection, you can set the optical axis angle

to 0 (zero). In this case, you will need to set the lens

position as follows.

You can install the following types of lenses for a zero

optical axis angle.

• Standard lens

• VPLL-ZM102 Long Focus Zoom Lens

• VPLL-FM22 Fixed Short Focus Lens

• VPLL-ZM32 Short Focus Zoom Lens

Turn off the power and disconnect the power

cable.

Remove the screw from the bottom of the unit by

using a Philips screwdriver .

(single long screw (M3))

Slide the top cover (top lens cover) forward, and

then lift it up to remove.

Remove the lens hood locking the lens by

loosening the four screws (M3×10, with washers)

with a Philips screwdriver.

Table of Contents

Vpl-px40