Epson Stylus Pro 7600 Quick Reference Manual
Hide thumbs
Also See for Stylus Pro 7600:
- Unpacking and setup manual (24 pages) ,
- Product support bulletin (104 pages) ,
- Manual (5 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Epson Stylus Pro 7600
Summary of Contents for Epson Stylus Pro 7600
- Page 1 EPSON Stylus Pro 7600/9600 ® Quick Reference Guide...
- Page 2 Slide the removable paper stop off the left end of Move the paper lever to the released position. the spindle. To use a 3-inch roll paper core, attach the gray adapters to the paper stops at each end. See your Printer Guide for details. Position the roll paper as shown, then slide it onto the spindle.
-
Page 3: Printing On Posterboard
For heavy paper, you may need to increase Make sure the printer is on and the roll paper the suction strength by pressing the button. cover is closed. This helps hold the paper in place during loading and printing. Press the Paper Source button until the Sheet light comes on. - Page 4 Open the front cover. (The cover has special tabs Return the paper lever to the locked position. that act as paper supports when the cover is Then close the front cover. open.) Feed the posterboard into the paper slot until it Press the Pause button.
- Page 5 Be sure to select the If the pattern is missing dots or lines, as shown below, paper you’re using in the EPSON printer software or in a you need to run a cleaning cycle.
-
Page 6: Replacing Ink Cartridges
* If your printer uses EPSON UltraChrome™ ink, the black ink cartridges may be either Photo Black, Matte Black, or Light Black. See your Printer Guide for more information on switching between black print modes. EPSON Photographic Dye ™... - Page 7 When one of the Ink Out lights stays on and INK OUT Hold the cartridge with the arrow mark pointing is displayed on the control panel, the cartridge is empty. toward the printer. Then insert the cartridge into To replace the cartridge, first make sure the printer is on. the slot.
-
Page 8: Service Life
Replacing the Cutter Blade Insert the new cutter blade. Hold down its side pin and secure it with the latch. If you notice that the paper isn’t cut cleanly, you may need to replace the cutter blade. You can check its status Close the printer cover. -
Page 9: Status Messages
MAINTENANCE REQ. A maintenance part will Note the error number and contact <error number> need to be replaced soon. EPSON. Continue... - Page 10 Support for non-EPSON RIP Contact the RIP manufacturer. EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON CORPORATION. EPSON UltraChrome and EPSON Photographic Dye are trademarks and EPSON Preferred is a service mark of Epson America, Inc. 6/03...