Table of Contents
Advertisement
3. HARDWARE SETUP
12) Wake-On-LAN Connector (3-pin WOL)
This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT:
This feature requires that Wake On LAN or PCI Modem is
enabled (see 4.5.1 Power Up Control) and that your system has an ATX power
supply with at least 720mA +5V standby power.
P4T
P4T Wake-On-LAN Connector
13) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT:
This feature requires that Wake On LAN or PCI Modem is
enabled (see 4.5.1 Power Up Control) and that your system has an ATX power
supply with at least 720mA +5V standby power.
P4T
P4T Wake-On-Ring Connector
38
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
®
WOL
Ground
PME
®
ASUS P4T User's Manual
+5 Volt Standby
Ring# Ground
2
1
WOR
Advertisement
Chapters
Table of Contents
