Warning Indicators - Sony VPL-HW55ES Operating Instructions Manual
Operating instructions
Hide thumbs
Also See for VPL-HW55ES:
- Quick reference manual (134 pages) ,
- Operating instructions manual (82 pages) ,
- Brochure & specs (4 pages)
Table of Contents
Advertisement
Available languages
Available languages
Warning Indicators
The ON/STANDBY or LAMP/COVER indicator lights up or flashes if there is any
trouble with your projector.
Symptom
LAMP/COVER flashes in
red. (A repetition rate of 2
flashes)
LAMP/COVER flashes in
red. (A repetition rate of 3
flashes)
ON/STANDBY flashes in
red. (A repetition rate of 4
flashes)
ON/STANDBY flashes in
red. (A repetition rate of 2
flashes)
ON/STANDBY flashes in
red. (A repetition rate of 6
flashes)
Note
When a warning indicator other than the above starts flashing, and the symptom persists even after
carrying out the above methods, consult with qualified Sony personnel.
68
GB
LAMP/COVER indicator
Cause and Remedy
c Close the lamp cover securely, then tighten the screws securely.
(1 page 72)
c Close the filter holder securely. (1 page 73)
c The lamp has reached the end of its useful lifespan. Replace the
lamp. (1 page 71)
c The lamp has reached a high temperature. Wait until the lamp
cools, and then turn on the power again.
c The fan is broken. Consult with qualified Sony personnel.
c The internal temperature is unusually high. Check to ensure that
if nothing is blocking the ventilation holes or whether or not the
projector is being used at high altitudes.
c Press the I/1 (ON/STANDBY) switch to turn on the projector.
If the power is not turned on, disconnect the AC power cord,
then confirm the ON/STANDBY lamp is turned off. After about
10 seconds, reconnect the AC power cord and turn on the power
again. If the indicators still light up, the electrical system has a
problem. Consult with qualified Sony personnel.
ON/STANDBY indicator
- Quick Links:
- Replacing the Lamp and the Air...
Hide quick links:
Advertisement
Chapters
Table of Contents
