Page 1
CDP-M11C SERVICE MANUAL US Model Canadian Model AEP Model UK Model E Model CDP-M11C is the CD section in CMT-M11C. Model Name Using Similar Mechanism CD Mechanism Type CDM42-5BD19 Base Unit Name BU-5BD19 Optical Pick-up Name KSS-213BA/S1NP SPECIFICATIONS COMPACT DISC PLAYER...
LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COM- POSANTS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
SECTION 1 SERVICING NOTES 1-1. MECHANISM MOTOR DIRECT DRIVE MODE • Functional Overview A mechanism has three motors (M400, M401 and M402), and if a motor does not run, each motor can be driven during the time that the button is pressed. •...
SECTION 3 DISASSEMBLY • This set can be disassembled in the order shown below. COVER, FRONT PANEL SECTION BACK COVER, MAIN BOARD REINFORCEMENT (TOP), CARRIER ASS’Y (Page 8) (Page 9) (Page 9) POWER/TRAY ADDRESS BOARD DISC TABLE ASS’Y, MOTOR DRIVE BOARD FRAME (L), (R) ASS’Y (Page 10) (Page 10)
BACK COVER, MAIN BOARD 7 FPC cable 1 supplied with OPT cap (CN104) 2 screw 3 two screws 3 screw (+BVTP3 × 10) (+BTTM3 × 6) 8 two screws 6 four connectors (+BTTM3 × 6) (+BVTT3 × 6) (CN100 - 103) 3 screw 5 rivet (+BTTM3 ×...
Page 10
POWER/TRAY ADDRESS BOARD 2 two screws (+P3 × 5) 3 power board 1 screw (+BVTP3 × 8) 5 sheet (S) 4 rivet 7 sheet (F) 9 four washers 6 three screws 8 tray address board (+P2.6 × 8) DISC TABLE ASS’Y, MOTOR DRIVE BAORD 8 motor dirve board 5 Remove the four solders of mode motor ass’y (M401),...
Page 11
6 frame (L), (R) ass’y FRAME (L), (R) ASS’Y 3 screw (P3 × 4) lever (up and down L) 2 screw 4 joint (middle) (BVTT3 × 5) lever (up and down R) 2 screw (BVTT3 × 5) 5 four screws 1 Rotate the worm gear in direction A Note: when mounting the frame (L) and (BV3 ×...
SECTION 4 SECTION 5 TEST MODE ELECTRICAL ADJUSTMENTS BD TEST MODE Notes: • Functional Overview 1. Use YEDS-18 disc (Part No.: 3-702-101-01) unless otherwise indicated. The BD test mode is used to check the BD block. When this 2. Use the oscilloscope with more than 10 MΩ impedance. mode is activated, a mechanism is kept in stop status and GFS 3.
SECTION 6 DIAGRAMS • Circuit Boards Location 5. Confirm that the oscilloscope waveform (S-curve) is symmetri- Traverse waveform cal between A and B. And confirm peak to peak level within 2.4 ± 0.7 Vp-p. LIGHT CONNECTOR board S-curve waveform symmetry MAIN board level: 300 ±...
• IC Block Diagrams – BD Section – IC101 CXA1782BQ – LEVELS 24 SENS – MIRR RF IV AMP1 DFCT 23 C. OUT – 22 XRST RF IV AMP2 21 DATA FE BIAS • IIL DATA RESISTOR • INPUT SHIFT RESISTOR •...
Page 20
IC102 BA6397FP DRIVE DRIVE DRIVE BUFFER BUFFER BUFFER DRIVE BUFFER REGULATOR DRIVER MUTE DRIVE DRIVE DRIVE DRIVE BUFFER BUFFER BUFFER BUFFER IC103 CXD2507AQ SERVO AUTO DATA SEQUENCER XRST SENS SUB CODE MUTE INTERFACE PROCESSOR DIGITAL LOCK SQCK TEST SQSO FILO EXCK DIGITAL FILI...
6-5. IC PIN FUNCTION DESCRIPTION • MAIN BOARD IC103 µPD78014FGC-532-AB8 (SYSTEM CONTROLLER) Pin No. Pin Name I / O Function C.SW2 Detection input from the chucking address switch (S402) C.SW1 Detection input from the chucking address switch (S401) G.SW2 Detection input from the gear select switch (S404) G.SW1 Detection input from the gear select switch (S403) B.SENS...
Page 23
Pin No. Pin Name I / O Function Main system clock output terminal (10 MHz) Main system clock input terminal (10 MHz) IC (VSS) — Not used (fixed at “L”) Sub system clock output terminal Not used (fixed at “L”) Sub system clock input terminal Not used (fixed at “L”) AVSS...
Page 25
(2) MAIN SECTION US, Canadian not supplied supplied with IC300 not supplied not supplied not supplied not supplied Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 4-933-134-51 SCREW (+PTPWH 2.6X8) * 56 4-986-532-11 COVER, BACK (US, Canadian, AEP, UK) * 52 A-4699-662-A MAIN BOARD, COMPLETE (US, Canadian) * 56...
Page 26
(3) FRAME (L), (R) ASS’Y SECTION (CDM42-5BD19) not supplied not supplied supplied not supplied supplied not supplied not supplied not supplied not supplied Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark X-4947-734-1 TRAIN ASSY, GEAR 4-986-319-01 GEAR (TRAY DRIVING) * 102 1-663-509-11 GEAR SELECT BOARD 3-669-595-00 WASHER (2), STOPPER...
Page 27
(4) CHASSIS SECTION (CDM42-5BD19) M401 not supplied not supplied M402 supplied M400 supplied supplied not supplied not supplied not supplied Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark * 151 X-4947-730-1 CHASSIS ASSY 4-986-310-01 GEAR (RACK DRIVING) 4-986-335-01 GEAR (MODE B) 4-986-347-01 GEAR (MODE C) 4-986-336-01 GEAR (MODE A)
Page 28
(5) CARRIER ASS’Y, OPTICAL PICK-UP SECTION (BU-5BD19) not supplied M101 M102 not supplied The components identified by Les composants identifiés par une mark ! or dotted line with marque ! sont critiques pour la mark ! are critical for safety. sécurité.
SECTION 8 ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • SEMICONDUCTORS The components identified by mark ! or dotted line with mark ! are parts list may be different from the parts speci- In each case, u: µ, for example: critical for safety.
Page 30
CHUCKING SW GEAR SELECT LIGHT CONNECTOR MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R124 1-216-091-00 METAL CHIP 1/10W 1-663-509-11 GEAR SELECT BOARD R125 1-216-069-00 METAL CHIP 6.8K 1/10W ****************** R126 1-216-063-00 METAL CHIP 3.9K 1/10W R127 1-216-089-00 METAL CHIP...