Table of Contents
Advertisement
FEEDER (ADF service mode)
DISPLAY (State display mode)
FEEDER (ADF service mode) > DISPLAY (State display mode)
FEEDSIZE
1
Detail
Use Case
Adj/Set/Operate Method
TRY-WIDE
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
ADJUST (Adjustment mode)
FEEDER (ADF service mode) > ADJUST (Adjustment mode)
DOCST
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Dspl orgnl size detected by DADF/Cpybrd
To display the original size detected by the DADF/Copyboard.
When checking the paper size recognized by the machine after scanning
N/A (Display only)
Distance of Original Width Detect Slider
To display the decuple value of the distance between the Original Width Detection Sliders.
At incorrect detection of original size
N/A (Display only)
Even if a value larger than 297.0 mm which is the maximum readable width is displayed, it does
not mean that the reading range changes. When reading an original of 297.1 mm or larger in width,
the edge of an image may be missing.
0 to 3048
mm
FEEDER> FUNCTION> TRY-A4
If the edge of an image is still missing after adjustment of A4 paper width (297.0 mm) with TRY-
A4, the original width may be larger than 297.1 mm.
0.1
Adj image lead edge margin: stream read
To adjust the leading edge margin of the image on the front side at stream reading.
Execute this item when the output image after DADF installation is displaced.
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of service label.
As the value is incremented by 1, the margin is reduced by 0.1 mm. (The image moves upward.)
The setting is applied to only the image on the front side in the case of DADF (1-path model) or
the images on both the front and back sides in the case of DADF (reverse model).
- When installing DADF
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-50 to 50
mm
0
0.1
928
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
