hit counter script

Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 693

Table of Contents

Advertisement

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > HV-TR
TR-DUP8
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
1TR-TGY
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
1TR-TGM
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
Sec trn indiv set clr mod/fd side: set 8
To set the color mode and feed side for setting 8.
Setting 8 is the combination condition of environment, paper type (paper weight), color mode/feed
side that are set in TR-ENV8, TR-PPR8 and TR-DUP8. When this condition is satisfied, the paper
allotted voltage adjusted in TR-VL8 is applied at the time of secondary transfer.
The left digit of the setting value represents the color mode and the right digit represents the feed
side.
When an image failure that differs on the 1st/2nd side occurs (mottled image/density loss due to
excessive transfer/toner scattering on solid image, etc.)
Enter the setting value, and then press OK key.
11 to 43
Left digit (color mode)
1: Color mode (entire paper), 2: Black mode (entire paper), 3: Color/black mode (leading edge of
paper), 4: Color/black mode (trailing edge of paper)
Right digit (feed side)
1: 1-sided, 2: Auto 2-sided, 3: Multi-purpose Tray 2-sided
11
COPIER> ADJUST> HV-TR> TR-ENV8, TR-PPR8, TR-VL8, 2TR-OFF
Up to 16 combination patterns can be set in TR-VL1 to 16 (setting 1 to 16). When there is more
than one setting where all conditions (environment, paper type and color mode/feed side) are the
same, the setting with a smaller setting number is applied.
Adj Y pry trns ATVC tgt crrnt:1/1 speed
To adjust the target current for Y-color upon primary transfer ATVC control at 1/1 speed. Increase
the value when low-voltage mottled image occurs, and decrease the value when fogging occurs
(especially in the 94 mm portion of the image leading edge).
The setting is reflected at the next primary transfer ATVC control.
When an image failure due to the primary transfer occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Execute 1ATVC-EX.
-50 to 50
uA
0
COPIER> FUNCTION> MISC-P> 1ATVC-EX
0.1
Adj M pry trns ATVC tgt crrnt:1/1 speed
To adjust the target current for M-color upon primary transfer ATVC control at 1/1 speed. Increase
the value when low-voltage mottled image occurs, and decrease the value when fogging occurs
(especially in the 94 mm portion of the image leading edge).
The setting is reflected at the next primary transfer ATVC control.
When an image failure due to the primary transfer occurs
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Execute 1ATVC-EX.
-50 to 50
uA
0
COPIER> FUNCTION> MISC-P> 1ATVC-EX
0.1
671
8. Service Mode

Advertisement

Table of Contents
loading

Table of Contents

Save PDF