Table of Contents
Advertisement
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > SYSTEM
DSRAMBUP
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
DSRAMRES
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
RSRAMBUP
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
RSRAMRES
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
R-REBOOT
Detail
Use Case
Adj/Set/Operate Method
FIXIP
Detail
Use Case
Adj/Set/Operate Method
Caution
2
Backup of DC Controller PCB SRAM
To back up the setting data in SRAM of the DC Controller PCB.
When replacing the DC Controller PCB for troubleshooting at the time of trouble occurrence
Select the item, and then press OK key.
During operation, the setting data changes by manual or automatic adjustment. When backup data
which has been left for a long period of time is restored, it is overwritten with new setting data and
the old data is deleted.
COPIER> FUNCTION> SYSTEM> DSRAMRES
2
Restore of DC Controller PCB SRAM
To restore the setting data which has been backed up in SRAM of the DC Controller PCB.
When replacing the DC Controller PCB for troubleshooting at the time of trouble occurrence
Select the item, and then press OK key.
During operation, the setting data changes by manual or automatic adjustment. When backup data
which has been left for a long period of time is restored, it is overwritten with new setting data and
the old data is deleted.
COPIER> FUNCTION> SYSTEM> DSRAMBUP
2
Backup of Reader Unit SRAM
To back up the setting data in SRAM of the Main Controller PCB.
When replacing the Main Controller PCB for troubleshooting at the time of trouble occurrence
Select the item, and then press OK key.
During operation, the setting data changes by manual or automatic adjustment. When backup data
which has been left for a long period of time is restored, it is overwritten with the old setting data
and the new data is deleted.
COPIER> FUNCTION> SYSTEM> RSRAMRES
2
Restore of Reader Unit SRAM
To restore the setting data which has been backed up in SRAM of the Main Controller PCB.
When replacing the Main Controller PCB for troubleshooting at the time of trouble occurrence
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
During operation, the setting data changes by manual or automatic adjustment. When backup data
which has been left for a long period of time is restored, it is overwritten with the old setting data
and the new data is deleted.
COPIER> FUNCTION> SYSTEM> RSRAMBUP
1
Reboot of host machine (Remote)
To reboot the host machine.
When the reboot is carried out with the remote control by VNC
Select the item, and then press OK key.
1
Start of fixed IP mode
IP address is set to "172.16.1.100".
In an environment where wired LAN (main) and wireless LAN (sub) are used, the IP address of
wired LAN becomes the fixed IP.
During the fixed IP mode, "FIXIP" is displayed on the upper left of the screen.
When preferring to use the network settings with the fixed IP address "172.16.1.100"
Select the item, and then press OK key.
- It is necessary to turn OFF/ON the power to recover from the fixed IP mode.
- Whether to use RUI or not when the fixed IP mode is enabled follows the setting of "Management
Settings> License/Other> Remote UI.
741
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
