Table of Contents
Advertisement
60
Getting Started
Adding memory
If you are adding an extra memory module after setting up the
computer, verify that the computer has recognized it correctly
as described in
Removing a memory module
To remove the memory module:
1
Turn the computer off and remove all cables connected to the
computer, including the AC adapter cable.
2
Close the display panel and turn the computer upside
down and remove the main battery module.
3
Loosen the screw that secures the memory slot cover,
then remove the memory slot cover.
4
Place the cover and screw in a safe place so that you can
retrieve them later.
5
Pull the clips away from the memory module.
The memory module pops partially out of the slot.
"Checking total memory" on page
Do not try to remove a memory module with the computer
turned on. You can damage the computer and the device.
Do not remove the memory module while the computer
is in Standby mode. The computer could hang up the
next time you turn it on and data in memory will be lost.
In either of the above cases, the Standby configuration
will not be saved.
The following message appears when you turn on the
power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
61.
Hide quick links:
Advertisement
Table of Contents
