Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 28
(usually zigzag) on the IDE ribbon cable to PIN 1. ® P4S800D PIN 1 P4S800D IDE Connectors PIN 1 FLOPPY1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. ® P4S800D P4S800D Floppy Disk Drive Connector 1-18...
Page 39
A:\>afudos /ip4s800d.rom AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading flash ..0x0008CC00 (9%) A:\>afudos /ip4s800d.rom AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading flash ..
Page 40
A:\>afudos /ip4s800d.rom AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc. All rights reserved. Reading file ..done Erasing flash ..done Writing flash ..0x0008CC00 (9%) A:\>afudos /ip4s800d.rom AMI Firmware Update Utility - Version 1.10 Copyright (C) 2002 American Megatrends, Inc.
Page 41
User recovery requested. Starting BIOS recovery... Checking for floppy... User recovery requested. Starting BIOS recovery... Checking for floppy... Floppy found! Reading file ìp4s800d.romî. Completed. Start flashing... Flashed successfully. Rebooting.
Page 42
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy found! Reading file ìp4s800d.romî. Completed. Start flashing...
Page 43
Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Bad BIOS checksum. Starting BIOS recovery... Checking for floppy... Floppy not found! Checking for CD-ROM... CD-ROM found. Reading file “p4s800d.rom”. Completed. Start flashing...
Page 45
Language [English] Use [+] or [-] to Primary IDE Master :[ST320413A] configure system time. Primary IDE Slave :[ASUS CD-S340] Secondary IDE Master :[Not Detected] Secondary IDE Slave :[Not Detected] OnChip SATA Controller :[Raid Mode] Select Screen System Information...
Page 46
Language [English] Use [+] or [-] to Primary IDE Master :[ST320413A] configure system time. Primary IDE Slave :[ASUS CD-S340] Secondary IDE Master :[Not Detected] Secondary IDE Slave :[Not Detected] OnChip SATA Controller :[Raid Mode] Select Screen System Information...
Page 47
Language [English] Use [+] or [-] to Primary IDE Master :[ST320413A] configure system time. Primary IDE Slave :[ASUS CD-S340] Secondary IDE Master :[Not Detected] Secondary IDE Slave :[Not Detected] OnChip SATA Controller :[Raid Mode] Select Screen System Information...
Page 48
Primary IDE Master Select the type Device : Hard Disk of device connected Vendor : ST320413A to the system. Size : 20.0GB LBA Mode : Supported Block Mode : 16 Sectors PIO Mode : Supported Async DMA : MultiWord DMA-2 Ultra DMA : Ultra DMA-5 SMART Monitoring: Supported...
Page 49
AMI BIOS Version : 08.00.08 Build Date : 03/12/03 : P4C81029 Processor Type : Intel(R) Pentium(R) 4 CPU 1.73GHz Speed : 1733 MHz Count System Memory Size : 256MB Select Screen Select Item Change Option General Help Save and Exit Exit 2-13...
Page 50
JumperFree Configuration Configure CPU. CPU Configuration Chipset Onboard Devices Configuration PCI PnP USB Configuration Speech Configuration Instant Music Configuration Select Screen Select Item Enter Go to Sub-screen General Help Save and Exit Exit AI Overclock Tuner [Standard] DRAM Frequency [Auto] Configure System Frequency Voltage CPU VCore Offset +0.1V [Disabled]...
Page 55
Onboard AC97 Audio Device [Enabled] Onboard SiS900 LAN Device [Enabled] Onboard LAN Boot ROM [Disabled] Select Screen Select Item Change Option General Help Save and Exit Exit Configure Win637 Super IO Chipset Serial Port1 Address [3F8/IRQ4] Serial Port2 Address [2F8/IRQ3] Parallel Port Address [Disabled] OnBoard Game/MIDI Port...
Page 57
Advanced PCI/PnP settings NO: Lets the bIOS configure all the WARNING: Setting wrong values in the sections below devices in the system. may cause system to malfunction. YES: Lets the Plug and Play OS [No] operating system PCI Latency Timer [64] configure Plug and Allocate IRQ to PCI VGA...
Page 58
OnBoard SiS USB1.1 DEVICE [Enabled] Enables USB host OnBoard SiS USB2.0 DEVICE [Enabled] controllers. USB Configuration Module Version : 2.23.0-7.4 USB Devices Enabled : None Legacy USB Support [Auto] USB 2.0 Controller Mode [HiSpeed] Select Screen Stop EHCI HC in OHCI handover [Enabled] Select Item Change Option...
Page 59
Instant Music Option Disable/Enable Instant Music feature. Instant Music [Disabled] Select Screen Select Item Change Option General Help Save and Exit Exit 2-23...
Page 60
Suspend Mode [Auto] Configure CPU. Repost Video on S3 Resume [No] ACPI 2.0 Support [No] ACPI APIC Support [Enabled] APM Configuration Hardware Monitor Select Screen Select Item Enter Go to Sub-screen General Help Save and Exit Exit 2-24...
Page 61
Power Button Mode [On/Off] Enabled or disable APM. Restore on AC Power Loss [Always OFF] Power On By PS/2 Keyboard [Disabled] Power On By PS/2 Mouse [Disabled] Power On By Internal MAC LAN [Disabled] Power On By PCI Devices [Disabled] Power On By External Modem [Disabled] Power On By RTC Alarm...
Page 62
Hardware Monitor CPU Temperature [44°C/111°F] MB Temperature [36°C/96.5°F] CPU Fan Speed [2250RPM] Chassis Fan Speed [XXX RPM] Power Fan Speed [XXX RPM] CPU Fan Control [Disabled] VCORE Voltage [1.550V] Select Screen 3.3V Voltage [3.386V] Select Item 5V Voltage [4.890V] Change Option 12V Voltage [11.900V] General Help...
Page 64
Specifies the boot sequence from the 1st Boot Device [First Floppy Drive] available devices. 2nd Boot Device [PM-ST320413A] 3rd Boot Device [PS-ASUS CD-S340] A device enclosed in parenthesis has been disabled in the corresponding type menu. Select Screen Select Item...
Page 65
Specifies the boot sequence from the 1st Boot Device [1st FLOPPY DRIVE] available devices. 2nd Boot Device [ASUS USB Flash Disk] 3rd Boot Device [ASUS USB Flash Disk] A device enclosed in parenthesis has been disabled in the corresponding type menu.
Page 66
Boot Settings Configuration Allows BIOS to skip certain tests while Quick Boot [Enabled] booting. This will Full Screen Logo [Enabled] decrease the time Add On ROM Display Mode [Force BIOS] needed to boot the Bootup Num-Lock [On] system. PS/2 Mouse Support [Auto] Wait for ‘F1’...
Page 67
Security Settings <Enter> to change password. Supervisor Password Not Installed <Enter> again to User Password Not Installed disable password. Change Supervisor Password Change User Password Clear User Password Select Screen Select Item Change Option General Help Save and Exit Exit 2-31...
Page 69
Exit Options Exit system setup after saving the Exit & Save Changes changes. Exit & Discard Changes Discard Changes F10 key can be used for this operation. Load Setup Defaults Select Screen Select Item Enter Go to Sub-screen General Help Save and Exit Exit 2-33...
Page 76
PLAY/PAUSE STOP/EJECT PREVIOUS NEXT VOL. DOWN VOL. UP ON/OFF CAPS SCROLL LOCK LOCK CD ON/OFF STOP/EJECT PLAY/PAUSE PREVIOUS NEXT VOL. DOWN VOL. UP...
Page 79
Silicon Integrated Systems Corp. RAID Card BIOS Setting Utility 1.00.0.XX (c) 2003-2005 Silicon Integrated Systems Corp. All Rights Reserved. Press <Ctrl><S> to run the BIOS Setting Utility.