If you are in any doubt about the safe installation of this unit, please consult your nearest Sony dealer. Do not install in locations which interfere with airbag operation Otherwise there is a risk of accidents and injury.
Table of Contents Precautions ........................2 Parts List ........................4 1 Installing the Main Unit ..................5 Before installation ......................... 5 Installation procedure ......................7 Installing the connection box XA-114 ................9 Hooking up the connection box ..................9 2 Main Unit Connections ..................10 Connection Example ....................
Parts List The numbers in the list are keyed to those in the instructions. 2.5 m ×4 ×2 ×2 Packed while being fixed to the main unit. Use this to replace the fuse or dismount the unit. Refer to the Operating Instructions for details. CAUTION Handle the bracket q;...
1 Installing the Main Unit Installation angle Before installation The unit should be installed within an angle of 25 degrees from horizontal. If This unit is designed to be completely safe, but if not installed this angle is exceeded, the monitor may correctly, it can cause accidents.
Page 6
Note Cluster panel dimensions If the installation dimensions shown at 175.4 right are not observed, the monitor may not open up smoothly. If this happens, check the installation once more and modify the cluster panel where the Center line dimension requirements are not met. For some car models, a separately available mounting kit may be required.
Installation procedure Mounting example When installing this unit, be sure to close the monitor of the unit. If the monitor is opened while installing and given too much force, it may cause a malfunction. 53 mm Bend these claws outward for a tight fit, if necessary.
Page 8
“T” on the side of the Media Center main unit, and use the supplied screws to fasten the brackets. For Toyota cars, the supplied screws 6 should be used. Front panel XAV-7W plate 4 Bracket of Do not throw away the front panel plate,...
Installing the connection box XA-114 Cut off the required length of hook-and-loop fastener 8 and fix the connection box 1 on the carpet or similar. Note • Ensure that the mounting surface is clean. • Do not install the connection box Hook-and-loop fastener 8 - in locations subject to high...
2 Main Unit Connections Refer also to the section “3 Car Systems Connections” (page 14 - 15). Use of connectors Insert until the connector clicks into place. To remove, press here and pull out. To connection Main unit/ connection box Insert until the connector clicks into interconnect 3 place.
Connection Example For details, see the section “3 Car Systems Connections” (page 14 - 15). Be sure to refer also to the documentation for all other components in the system. Speaker connections Front speakers (optional) Media Center main unit SUB WOOFER OUT(MONO) Rear speakers (optional)
Page 12
Connection of separately available accessories Items except the main unit and the connection box are optionally available. With Sony bus system TV tuner unit XT-63V (NTSC system) CONTROL(IN) CONTROL(OUT) TV tuner unit CD/MD changer, or INPUT Source selector XA-C30 OUTPUT...
Be sure to connect the parking cord (Light green) to the parking brake switch cord. The mounting position of the parking brake switch cord depends on your car. Refer to the system connection diagram below and consult your car dealer or your nearest Sony dealer for further details. Battery power...
3 Car Systems Connections Refer also to the documentation for all other components in the system. Also see “Connecting Information” on page 13. • Components listed here except for supplied accessories are available separately. When connecting such components, be sure to also refer to their documentation. For specifications and other information on separately available components, contact your dealer.
Page 15
RCA interconnects Bus cable (5.3 m) (supplied with XT-63V) (optional) RCA interconnects Front speakers (5.3 m) (supplied with (optional) XT-63V) Amplifiers RCA interconnects (optional) CONTROL INPUT (optional) Rear speakers Connection (optional) box 1 RCA interconnects TV tuner unit Main unit/ (optional) XT-63V connection box...
4 After Installation and Connections Start the car’s engine. Verify that the brake lights, other lights, horn, turn indicators, and all other electrical parts operate normally. Note To avoid the possibility of damage, you Use a ball-point pen or similar to push the Reset should not use a needle or push the button on the unit.
Removing the Front Panel Plate To remove the front panel plate from the unit, use the following procedure. Insert a coin and twist to remove the front panel plate. Be careful not to pull off the plastic parts. Front panel plate Plaque de panneau avant Pull the lower side of the front...
Page 27
SUB WOOFER OUT(MONO) FRONT AUDIO SUB WOOFER REAR AUDIO OUT(MONO) • •...
Page 28
CONTROL(IN) CONTROL(OUT) INPUT OUTPUT VIDEO IN CONTROL INPUT REAR MONITOR OUTPUT INPUT1/2 CONTROL(IN) CONTROL(OUT) INPUT OUTPUT VIDEO IN CONTROL INPUT REAR MONITOR OUTPUT INPUT1/2...