Replacing Recording On A Tape - Insert Editing - Sony Handycam Vision DCR-TRV5 Operating Instructions Manual
Sony operating instructions digital video camera recorder dcr-trv5
Hide thumbs
Also See for Handycam Vision DCR-TRV5:
- Service manual (165 pages) ,
- Operating instructions manual (91 pages) ,
- Service manual (25 pages)
Table of Contents
Advertisement
Replacing recording on a tape – insert
editing
You can insert a new scene from a VCR onto your originally recorded tape by
specifying starting and ending points. After inserting editing, the previous picture and
sound will be erased.
Connection is the same as on page 59. In recording and recording pause mode, DV
IN/OUT jack automatically works as input jack.
You can only operate with the Remote Commander.
(1) While pressing the small green button on the POWER switch, set it to VTR.
(2) On the VCR, locate the start point to be inserted and set it to playback pause
mode.
(3) On the camcorder, press ( to set it to playback mode, and then locate the
point where the insert should end by pressing 0 or ). Then press P to set
it to playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
MEMORY indicator flashes and the end point of the insert is stored in
memory.
(5) On the camcorder, locate the point where the insert should begin by pressing
0, then press r REC on the Remote Commander to set it to recording pause
mode.
(6) Press P on the camcorder and the VCR simultaneously to start insert editing.
The insert editing stops automatically near the counter's zero point. Press p to set the
camcorder to stop mode.
To change the end point
Press ZERO SET MEMORY on the Remote Commander so that the ZERO SET
MEMORY indicator disappears and begin from step 3.
Note on the inserted picture
The picture may be distorted at the end of the inserted portion when it is played back.
61
Advertisement
Table of Contents
