Getting Started; Charging And Installing The Battery Pack - Sony Handycam Vision DCR-TRV5 Operating Instructions Manual

Sony operating instructions digital video camera recorder dcr-trv5

Hide thumbs Also See for Handycam Vision DCR-TRV5:

Table of Contents

Getting started

Before using your camcorder, you first need to charge and install the battery pack. To

charge the battery pack, use the supplied AC power adaptor.

This camcorder operates only with the "InfoLITHIUM" battery pack.

"InfoLITHIUM" is a trademark of Sony Corporation.

Charging the battery pack

Charge the battery pack on a flat surface without vibration.

(1) Connect the power cord to the AC power adaptor.

(2) Align the surface of the battery pack indicated by the z mark with the edge of the

terminal shutter of the AC power adaptor. Then fit and slide the battery pack in the

direction of the arrow.

(3) Connect the AC power cord to a wall outlet. The CHARGE lamp (orange) lights up.

Charging begins.

When the CHARGE lamp goes out, normal charge is completed. For full charge,

which allows you to use the battery longer than usual, leave the battery pack in

place for approximately one hour. Unplug the unit from the wall outlet, then remove

the battery pack and install it into the camcorder. You can also use the battery pack

before it is completely charged.

Charging time

Battery pack

NP-F330 (supplied)

NP-F550

NP-F530

The time required for a normal charge is indicated in parentheses.

* Approximate minutes to charge an empty battery pack using the supplied AC power

adaptor. (Lower temperatures require a longer charging time.)

Charging time *

130 (70)

180 (120)

170 (110)

CHARGE

Table of Contents