Table of Contents
Advertisement
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > INSTALL
STRD-POS
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Required Time
Related Service Mode
CARD
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
INISET-Y
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Required Time
Related Service Mode
Auto adj frt side read pstn: DADF stream
To automatically adjust the Scanner Unit (for front side) position in feed direction when stream
reading original with DADF.
The adjustment result is reflected to COPIER> ADJUST> ADJ-XY> STRD-POS.
At DADF installation/uninstallation
1) Close the DADF.
2) Select the item, and then press OK key.
The operation automatically stops after the adjustment.
3) Write the value displayed by COPIER> ADJUST> ADJ-XY> STRD-POS in the service label.
Write the adjusted value in the service label.
At normal termination: OK!, At abnormal termination: NG!
10 sec
COPIER> ADJUST> ADJ-XY> STRD-POS
Card number setting
To set the card number to be used for Card Reader.
A series of numbers from the entered number to the number of cards specified by CARD-RNG
can be used.
- At installation of the Card Reader
- After replacement of the HDD
1) Enter the number, and then press OK key.
2) Turn OFF/ON the main power switch.
The card management information (department ID and password) is initialized.
1 to 2001
1
COPIER> OPTION> FNC-SW> CARD-RNG
Exe of Dev Unit (Y) initial install mod
To automatically execute operation necessary for initial installation of the Developing Unit (Y).
1. Idle rotation of the Developing Unit (including automatic take-up of the developer sealing)
2. Dark current correction of the Registration Patch Sensor and light intensity adjustment
3. Initialization of the Toner Density Sensor (Y)
4. Primary transfer ATVC control
5. Initialization of the Registration Patch Sensor
6. Cleaning of the Secondary Transfer Outer Roller
7. Reset of the Developing Unit counter
When replacing the Developing Unit (Y)
Select the item, and then press OK key.
When installing the machine or replacing the Developing Unit of other color, do not use this item.
During operation: xxx second (remaining time), At normal termination: OK, At abnormal
termination: NG
180 sec
COPIER> FUNCTION> INSTALL> INISET-M/C/K/4
716
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
