Color Reproduction Adjustment - Sony DCR-TRV5 Service Manual
Digital video camera recorder
Hide thumbs
Also See for DCR-TRV5:
- Operating instructions manual (92 pages) ,
- Operating instructions manual (91 pages) ,
- Service manual (25 pages)
Table of Contents
Advertisement
8. Color Reproduction Adjustment
Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
Subject
Color bar chart standard picture frame
Measurement Point
Video output terminal
Measuring Instrument
Vectorscope
Adjustment Page
F
Adjustment Address
2E, 30, 8F, 90
Specified Value
All color luminance points should
settle within each color reproduction
frame.
Adjusting method:
1) Select page: 6, address: 00, and set data: 01.
2) Select page: 6, address: 01, set data: 3D, and press the PAUSE
button of the adjustment remote commander.
3) Select page: F, address: 16, set data: 3F, and press the PAUSE
button of the adjustment remote commander.
4) Adjust the GAIN and PHASE of the vectorscope, and adjust
the burst luminance point to the burst position of the color
reproduction frame.
5) Change the data of page: F, address: 2E, 30, 8F and 90, and
settle each color luminance point in each color reproduction
frame.
Note: Be sure to press the PAUSE button of the adjustment remote
commander before changing the addresses. If not, the new data
will not be written to the memory.
6) Press the PAUSE button of the adjustment remote commander.
Processing after Completing Adjustments:
1) Select page: 6, address: 01, and set data: 00, and press the
PAUSE button of the adjustment remote commander.
2) Select page: 6, address: 00, and set data: 00.
For NTSC model
Burst position
For PAL model
Burst position
5-12
Fig. 5-1-9
Advertisement
Table of Contents
